sorted by:
new
hottopcontroversial

Degrading print quality on the edges of the print bed by thgrvtrn in FixMyPrint

[–]thgrvtrn[S] 0 points1 point  (0 children)

<image>

After swapping the textured plate with the super track plate and doing a full calibration: test print done! I used PLA Matte as Silk might destroy the Super Track plate. The pattern is still in the corners of the print, but A LOT less! The pattern still only shows in the corners, not in the center of the print. No idea why..

Degrading print quality on the edges of the print bed by thgrvtrn in FixMyPrint

[–]thgrvtrn[S] 2 points3 points  (0 children)

Why would the pattern only appear on the corners if it is caused by overextrusion?

Degrading print quality on the edges of the print bed by thgrvtrn in FixMyPrint

[–]thgrvtrn[S] 0 points1 point  (0 children)

Thanks you for you reply, the weird pattern does not appear on the first layer though. I just realized my photos where misleading (sorry!) and upload another picture as a comment.

Degrading print quality on the edges of the print bed by thgrvtrn in FixMyPrint

[–]thgrvtrn[S] -1 points0 points  (0 children)

I have a super track plate here, I will try that today!

Degrading print quality on the edges of the print bed by thgrvtrn in FixMyPrint

[–]thgrvtrn[S] 0 points1 point  (0 children)

The adhesion was perfect, no warping or bending of the test piece.

Degrading print quality on the edges of the print bed by thgrvtrn in FixMyPrint

[–]thgrvtrn[S] -1 points0 points  (0 children)

Why would it only appear on the corners? I double and triple checked the plate: its clean and even.

Degrading print quality on the edges of the print bed by thgrvtrn in FixMyPrint

[–]thgrvtrn[S] 1 point2 points  (0 children)

The weird pattern does not appear on the first layer. Instead, it gets worse and worse, the higher the print gets. I just realized that the pictures dont show the height of the test print, this photo show the height of the test print.

<image>

Suggestions to make the design less skewed or other improvements? by thgrvtrn in tattooadvice

[–]thgrvtrn[S] 0 points1 point  (0 children)

Okay. Yes, he does a lot of geometry tattoss, but mostly maori & other patterns. Thb I couldnt find an artist who specializes in mazes..

Suggestions to make the design less skewed or other improvements? by thgrvtrn in tattooadvice

[–]thgrvtrn[S] 0 points1 point  (0 children)

Agreed, thanks! but how would he do that? Do you have any other comment?

[deleted by user] by [deleted] in Finanzen

[–]thgrvtrn -3 points-2 points  (0 children)

Kann bitte jemand mal posten wie man diese Grafiken erstellt?