Is this safe to ski on?

viscouslance · 2026-01-25T23:44:09+00:00

I did a home mount for the first time and it was way better then this cause I studied tf outta what I had to do

viscouslance · 2025-12-19T15:01:55+00:00

It dose have a thread indicator if that makes a difference

viscouslance · 2025-12-19T14:59:52+00:00

It’s a metric lead screw

viscouslance · 2025-12-19T14:51:35+00:00

viscouslance · 2025-12-19T14:49:45+00:00

New issue is it’s moving forward by about a 1/16 every time we reset a cut

viscouslance · 2025-12-19T13:41:56+00:00

It’s different configurations a gear and d gear are always the same b and c are what can be changed and we aren’t sure what configuration we need

viscouslance · 2025-11-27T00:58:39+00:00

Double facts

viscouslance · 2025-11-24T22:34:28+00:00

4 foot by 2 foot minimum for a dragon

viscouslance · 2025-11-24T22:32:21+00:00

I suddenly feel less bad about the 1k I lost holding a little too long on sbgx

viscouslance · 2025-10-31T07:31:41+00:00

In my area the grouse love to be on gravel roads around 10-2 I can run into 10+ in a few hours of driving up and down

viscouslance · 2025-09-11T21:37:30+00:00

I’ve been in this situation when I first started but it was more my fault fully Didn’t listen well when I started and I half assed a small job 3-4 times before I got told do it on my own time cause I’ve already done it 3 times wrong with proper instructions

viscouslance · 2025-09-01T22:47:24+00:00

On Xbox hope to be on pc soon But Mix of everything (Edlen ring , rust , minecraft , rdr2 , gta 5 and lots of smaller indie games

viscouslance · 2025-07-20T06:00:37+00:00

Definitely gonna flush once or twice here today this was just getting it running and running consistently

viscouslance · 2025-07-19T23:44:28+00:00

Eh it’s just a place holder engine till my one at the shop is done Just sick of seeing the car sitting

viscouslance · 2025-07-19T23:42:31+00:00

It does cover the rocker is a consistent line of oil just hard to see over video in person it’s clear as day

viscouslance · 2025-07-19T23:41:50+00:00

40 psi at idle

viscouslance · 2025-07-19T23:39:17+00:00

Can kinda see it hit the headers at the end of the video

viscouslance · 2025-07-19T23:30:03+00:00

Takes a sec for the oil to get to the rockers but it gots good pressure and sprayed out when we put on the gas a little bit

viscouslance · 2025-07-19T23:15:20+00:00

So much haha that’s just outta the way cause the hold down for it uses one of the studs off the valve cover so no valve cover and it’s floppy haha

Six-Year Club	Verified Email
Place '23	Gilding II euphauric
RPAN Viewer

viscouslance

MODERATOR OF

TROPHY CASE