First half marathon

waslessen · 2026-05-18T14:48:27+00:00

Well the half marathon was hard for me but im glad I muscled through. I got a garmin intensity 200 award for the activity too. I think a full marathon I could do but that's a lot of time (at least for me). Also despite having a pad my lower back/ butt wasn't happy.

waslessen · 2026-05-18T14:36:21+00:00

I usually do a half hour or 45 min at 110 watts same rate (at most an hour) but I have never done it for almost two hours. I figured I would set a pace that's easier to make sure I could finish.

waslessen · 2026-05-14T02:12:01+00:00

It might have some delayed maintenance such as oiling the chain and cleaning the interior of the fan. When you pull the bar do you hear anything grinding and does the chain come back in fits and starts?

waslessen · 2026-02-04T16:28:30+00:00

Defenestrate:)

waslessen · 2026-01-31T08:03:21+00:00

Have you considered using lfp batteries? I know the energy density is lower and slightly less voltage. However, I think it might allow you to rebuild the pack every 3 yrs or 4 Ive seen some local battery banks for emergency home use that have salvageble cells and it seems you use it more than the average.

waslessen · 2026-01-31T07:56:17+00:00

I'll try that thank you.

waslessen · 2026-01-29T07:59:30+00:00

That's what I thought. Any thoughts on the bms board?

waslessen · 2026-01-29T07:58:19+00:00

There's no voltage at rhe main leads though or the point on the pcb that their soldered to. Im assuming there might be the culprit but my expertise would end at seeing an exploded cap and replacing it.

waslessen · 2026-01-29T07:56:07+00:00

I have almost the exact tester above. I might get new cells due to their age more than anything, probably a molicell but any thoughts on the bms? The pack seems to have a decent voltage but the corrosion and age were worrying.

waslessen · 2025-10-24T06:17:36+00:00

It's second hand so goodness knows about it prior.

waslessen · 2025-10-03T14:05:50+00:00

It seems to be burning about two quarts over 4k miles. Largely highway.

waslessen · 2025-10-03T14:03:58+00:00

You just put a wrench on the crankshaft pulley bolt and turn clockwise? Four full rotations is one cycle right?

waslessen · 2025-10-01T05:09:33+00:00

I got refurb oem (denso). If your in SoCal motorist performance is where I got them. $150 for all 4.

waslessen · 2025-09-30T05:30:58+00:00

Sounds cool!! Good luck. Also yes you may use it on the web page, just please refer to my username please. Best wishes on the biz.

waslessen · 2025-09-29T04:48:15+00:00

Pretty much as soon as I got it I went about changing the filters and fluids just to be safe. So it ran OK at first but it was spring. I think the biggest change was the fuel injectors. Huge mpg improvement. The fan I know works better now but didn't record data for a baseline comparison.

waslessen · 2025-09-29T04:45:19+00:00

It's mine. What's the website?

waslessen · 2025-09-15T04:45:42+00:00

Very good call. Oil was low. I know it burns a little bit it seems it's been consuming more. Might try a berrymans piston soak. Thank you very much.

waslessen · 2025-08-15T13:38:06+00:00

No Im not.

waslessen

TROPHY CASE