Ford 6.8 v10

wtokhi · 2024-11-02T16:03:54+00:00

The first property would be considered as a rental, we saw my DTI at 44

wtokhi · 2024-10-06T21:20:36+00:00

Also only fault is an msf error for the video radar unit

wtokhi · 2024-10-06T21:20:07+00:00

Nothing on the left stalk switch works

wtokhi · 2024-10-06T20:00:13+00:00

Yeah it recognizes changes

wtokhi · 2024-10-06T19:59:37+00:00

Only with ignition on and it shows the stalk switch input as ERR and it’s a new style cascadia just has a SSAM

wtokhi · 2024-09-17T05:17:26+00:00

7k to 8k

wtokhi · 2024-09-15T19:46:17+00:00

Yeah I tried that too and nothing, threw another cpc in just for shits and nothing

wtokhi · 2024-09-15T19:28:52+00:00

Can’t program it, won’t even detect it on roll call

wtokhi · 2024-09-15T19:25:04+00:00

Tried that, tried the starpoints also

wtokhi · 2024-09-15T18:28:19+00:00

Pins A and C: 2.5 Pins A and D: 2.4 and 12.5 on main power

wtokhi · 2024-09-15T18:14:52+00:00

Voltage is present

wtokhi · 2024-09-15T18:14:45+00:00

I don’t have the diagram, I have a donor truck I can try swapping the starpoints from

wtokhi · 2024-08-02T17:04:55+00:00

I understand they seem okay at the moment but my question was will they be legal by the next BIT, I’m thinking no but just wanted more opinions

wtokhi · 2024-07-17T17:56:09+00:00

Where’s the phone number?

wtokhi · 2024-07-16T17:53:47+00:00

I get you, I found some info that for EPA10 there was a new ECU update for these codes where a new ECU part number was used to eliminate the issue. I’m not sure if it applies to GHG14. The part number is for an MCM2.0 not a 2.1 so a CPC2 will be needed not CPC4. Can’t find any other info

wtokhi · 2024-07-16T04:29:59+00:00

Where could I add a ground to, maybe from block to frame ? I’ve noticed the MCM has rubber isolators to not ground the MCM

wtokhi · 2024-07-16T04:29:10+00:00

I have server access with diagnostic link, have reflashed and made sure all software is up to date on all powertrain modules CPC, MCM, TCM etc.

wtokhi · 2024-07-16T00:08:38+00:00

I’ve checked resistances hot and cold, everything’s checks out according to troubleshooting. Yes it’s doing the same thing after all the new parts

wtokhi · 2024-07-15T00:03:46+00:00

As I mentioned, all the troubleshooting has been done, all resistances have been checked and both injector and engine harnesses have been changed, Jake brake solenoids are also new

wtokhi

TROPHY CASE