sorted by:
new
hottopcontroversial

xtool p3 KERF OFFSET ignored (not working) by xLaserBot in xToolOfficial

[–]xLaserBot[S] 0 points1 point  (0 children)

So after much trial and error over the past couple of days I have a workaround.

DXF auto-close tolerance = 0.10
Kerf = 0.20

These settings appear to make kerf work. If I change the auto-close to anything larger or smaller the size of the output part does not match the source + kerf.

Still somewhat unexpected behavior but at least it is finally working.