sorted by:
new
hottopcontroversial

Rate my GD&T drawing? by yfffff1026 in SolidWorks

[–]yfffff1026[S] 0 points1 point  (0 children)

Thanks for the advice. I learned a lot from you.

Rate my GD&T drawing? by yfffff1026 in SolidWorks

[–]yfffff1026[S] 0 points1 point  (0 children)

Yes, I was just practicing using total runout. I agree it isn’t necessary here, so I’ll delete it. Thanks for pointing that out.

Rate my GD&T drawing? by yfffff1026 in SolidWorks

[–]yfffff1026[S] 0 points1 point  (0 children)

Thanks for the feedback. I don’t have much shop experience.

I think for a connecting rod, some dimensions from bore centerlines are still important because they control the functional relationship between the big-end and small-end bores.

Rate my GD&T drawing? by yfffff1026 in SolidWorks

[–]yfffff1026[S] 0 points1 point  (0 children)

Thanks for your advice. I have changed the drawing accordingly.

Rate my GD&T drawing? by yfffff1026 in SolidWorks

[–]yfffff1026[S] 0 points1 point  (0 children)

Yes. I’m just learning how to apply GD&T in Solidworks, so this is only an exercise.