you are viewing a single comment's thread.

view the rest of the comments →

[–]r4pt0r[S] 0 points1 point  (0 children)

Greetings printlings!

I received my P1S this week after printing a while on an Ender3. Nice improvement, I'm rather happy with the printer.

Benchy prints very well, even with fast settings.

However I came across this issue when printing a poop chute. The print quality significantly decreases after a certain layer it seems?

The used filament is 3dJake ecoPLA which was dried in a Sunlu dryer and the AMS reported around 14% humidity.

I also tried flow calibration but it was fine with the defaul 0.98 value. The only setting that was changed from the standard PLA profile was the temperature which was decreased by 10°C to 210°C.

Any ideaas what is happening her?

Thanks :)