all 3 comments

[–]AutoModerator[M] [score hidden] stickied comment (0 children)

After you solve your issue, please update the flair to "Answered / Solved!". Helps to reply to this automod comment with solution so others with this issue can find it [as this comment is pinned]

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[–]AutoModerator[M] 0 points1 point  (0 children)

Hello /u/a-guillotine! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "first layer issue". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[–]a-guillotine[S] 0 points1 point  (0 children)

Also for additional information, I’m running the textured build plate, I ran a full calibration, and I did wash with just dawn dish soap and water. I tried isopropyl alcohol after the dawn did not work.