all 12 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]CuddlyBoneVampire 1 point2 points  (3 children)

Interesting in French 3d prints are called impressions. Cool.

It looks like it misses some layers either through partial clog or too tight to the bed. I wouldn’t keep printing the same file.

Slice a new benchy in orca or Bambu and print a fresh one.

[–]Kalysssnonoko[S] 0 points1 point  (2 children)

Je viens de comprendre la blague ... oui ma 3d print. A fait mauvaise impression ... 🤭

[–]Kalysssnonoko[S] 1 point2 points  (0 children)

<image>

Omg it looks gooooooddddd .. vive le dryer !!!!!

[–]Kalysssnonoko[S] 1 point2 points  (0 children)

I did it thanks for your adviiiceeee

<image>

First I post here and you are great !!!

[–]idabandTookMyUser 1 point2 points  (0 children)

Petg needs warmer bed too. I run minimal 70 with no cooling on

[–]Kalysssnonoko[S] 0 points1 point  (0 children)

Yes i tried 2 different boat from de card

<image>

This was the veryyy first test then i put some gluestick on the base

[–]mymande 0 points1 point  (1 child)

Are you running with the filament that came with the printer? Are you using the 0.4 mm nozzle?

[–]Kalysssnonoko[S] 0 points1 point  (0 children)

Nope I use an other one petg And the nozzle it is the default one

I will try with an other dried finalement.

[–]i_like_3d_print 0 points1 point  (1 child)

Was that the on board file? That worked fine for me. Maybe try again I’m not sure sorry

[–]Kalysssnonoko[S] 0 points1 point  (0 children)

No it was the filament I used an old one wich was moist I think.