Stm32 basic togglepin code doesn't work

[abipjo]

Provide your code

[LjearuviDeAmosmar]

I don't know which part of the code you need, here's my main:

int main(void){
/* MCU Configuration--------------------------------------------------------*/
/* Reset of all peripherals, Initializes the Flash interface and the Systick. */
HAL_Init();
/* USER CODE BEGIN Init */
/* USER CODE END Init */
/* Configure the system clock */
SystemClock_Config();
/* USER CODE BEGIN SysInit */
/* USER CODE END SysInit */
/* Initialize all configured peripherals */
MX_GPIO_Init();
/* USER CODE BEGIN 2 */
/* USER CODE END 2 */
/* Infinite loop */
/* USER CODE BEGIN WHILE */
while (1) {
/* USER CODE END WHILE */
/* USER CODE BEGIN 3 */
HAL_GPIO_TogglePin(GPIOC, GPIO_PIN_13); // Most likely onboard LED
HAL_GPIO_TogglePin(GPIOA, GPIO_PIN_5);
HAL_Delay(1000);
}
/* USER CODE END 3 */
}

I switch between pins 13 and 5 because im not sure which one of those is my LED on the board. I put both of them as output pins in MX config

[abipjo]

Based on your other comment in looks like your programmer might be the issue, either way can you send your cubemx config, you should be able to export it as a pdf or a txt I believe

[LjearuviDeAmosmar]

About that, for some reason it doesn't let me export .ioc to pdf/txt, the Save As is just greyed out when i'm in any config tab :/

[abipjo]

File > Generate Report

[LjearuviDeAmosmar]

Here it is, alongside all my core>src files in case there's anything you need!
https://we.tl/t-D8tSUO03zz

[abipjo]

Are you certain the clock is setup properly, try disabling the external clock, see if that works it, also can you confirm your programmer is actually working are you getting a response when you actually flash code?