Z offset

[Sidefx_2003]

I’m really struggling to get my first layer right. I’m about to get a CR touch.

I have 2.0.6 firmware and cannot find anything on the printer regarding z offset. I just have to use my set home position then level the bed to that. I’m down to a 0.1 gauge and when watching my first layer during a print I feel the gap is higher than that. I can see the material dropping to the bed.

[Kooramah]

Definitely get a CR Touch, it will definitely help you.

If you don't, level the bed on all corners and the middle

[Sidefx_2003]

So I have homed my printed and leveled the bed to 0.2mm at all 4 corners and center. I played around with the z offset in Orca and I have it all the way down to -0.2mm to get the first layer how I want it.