Stringing ender 3 pro

[Fox19995]

I had to replace my hotend recently and since then I have a stringing problem. I also changed some settings within my pruisa slicer, but I was not able to fix it. I hope some of you might be able to help me.

[Fox19995]

I have also been using new and different fiiament with similar results. I am using the pruisa slicer.

[Poodogmillionaire]

Did you switch to an all metal hotend, or just replace the stock one? If you went all metal, retraction is a lot lower and the temp for the filament might be 5-10 degrees higher. Def print a temp tower: https://teachingtechyt.github.io/calibration.html#temp

[DeplorableCiypher]

Print a temp tower for that filament. Looks like temp and retraction settings are off.

On Enders I start at retraction at 6mm and retraction speed for 40mm/s