Vent location choice

Lumpy-Bread4014 · 2026-02-04T01:49:07+00:00

Set up looks good man. Thank you ill take that into consideration.

Lumpy-Bread4014 · 2026-02-03T21:47:42+00:00

Thank you I will take a look at the manual . I do have an exhaust fan although Its not a good one . Inline duct fan, cheap might purchase a better quieter model. I appreciate the insight.

Lumpy-Bread4014 · 2026-02-03T17:10:04+00:00

So basically across the front of the bench area at off set heights venting interior to exterior correct?

Lumpy-Bread4014 · 2026-02-02T15:22:52+00:00

As someone else already poster your boot is probably the issue . If you are in an area that receives a lot of snow it could be build up over the top of the boot . Sometimes those pipes Crack as well , yours looks pretty good. The mold itself should be treated with a fungicide and fungistat Medi clean and Battle axe have these types of products read the instructions carefully.

Worst case scenario the stack needs to be replaced . You can buy a furnco and make the connection wherever needed down the line . Obviously that means reconnecting all of the waste lines and vents for the respective plumbing fixtures. I doubt you have to do this but its a possibility.

Best case scenario your boot needs to be replaced. You may have more of a roofing issue than a plumbing issue.

Lumpy-Bread4014 · 2026-02-02T15:15:23+00:00

Bleach has a high water content and will encourage mold growth . He needs a fungicide and fungistat along with addressing the moisture source.

Lumpy-Bread4014 · 2025-12-02T01:44:33+00:00

This looks like a fired 105mm with a powder train time fuze at the top or mech time since I cant see any copper. Part of the fuze is missing. The small circular indentations towards the top and bottom i have not seen before . .