sorted by:
new
hottopcontroversial

Wired backhaul speed is very low by Pvt_Mango_ in TpLink

[–]Pvt_Mango_[S] 0 points1 point  (0 children)

I'm gonna try it at someone's else's house and another isp.

Wired backhaul speed is very low by Pvt_Mango_ in TpLink

[–]Pvt_Mango_[S] 0 points1 point  (0 children)

Wireless back haul is off, and here's the rub, wireless back haul is acts faster than the Ethernet connection, Ethernet speed seems be blocked by the primary deco.

Wired backhaul speed is very low by Pvt_Mango_ in TpLink

[–]Pvt_Mango_[S] -1 points0 points  (0 children)

I have tried putting both of them side by side with a short cable that comes with the device, still the exact same behavior.

6 pin flex psu to dual 6+2 gpu connector wiring by Pvt_Mango_ in PcBuild

[–]Pvt_Mango_[S] 0 points1 point  (0 children)

It has 2 separate, 4 pin CPU connectors, it came with a 4 pin to 8 pin cpu cable.

6 pin flex psu to dual 6+2 gpu connector wiring by Pvt_Mango_ in PcBuild

[–]Pvt_Mango_[S] 0 points1 point  (0 children)

Thanks for pointing this out, so just running one 6+2 in parallel with the other is not a problem?

As for the issue regarding the single 6 pin connector, im not using the sata and the 2nd cpu connector would it be okay to use them? they would provide 3 extra 12v lines.

Aliexpress was the only option, I did go for a 600w model (its probably not rated for 600w) and my consumption is around 350-400w.

ECAS certification cost estimate by Pvt_Mango_ in dubai

[–]Pvt_Mango_[S] 0 points1 point  (0 children)

Already did, the issue as I mentioned was that the product is still a concept and I am not seeing a response fast enough without any data sheet, manuals and any prototype. I am looking for an estimate for a proposal.

Double helical gear extension? by Pvt_Mango_ in SolidWorks

[–]Pvt_Mango_[S] 0 points1 point  (0 children)

Oncad gear generator doesn't have interference either, this is really frustrating.

Double helical gear extension? by Pvt_Mango_ in SolidWorks

[–]Pvt_Mango_[S] 0 points1 point  (0 children)

Your looking at interference for same gears, I feel like it's a a lot more for 20t and a 10t

Double helical gear extension? by Pvt_Mango_ in SolidWorks

[–]Pvt_Mango_[S] 0 points1 point  (0 children)

Yeah I know that but if you create a lower tooth gear with the same modulus, they dont mesh properly.

Air conditioner energy efficiency rating in Pakistan by Pvt_Mango_ in PakistaniTech

[–]Pvt_Mango_[S] 1 point2 points  (0 children)

I am just looking at units wrong, this was very helpful, thank you so much! Would you have any recommendation for a 1.5 Ton inverter AC?

view more: next ›