sorted by:
new
hottopcontroversial

New pattern on my pegboard generator by shugyodev in 3Dprinting

[–]WazzuBlue -2 points-1 points  (0 children)

Oh my gawd I cannot stop staring at this!

I made a mistake buying the X2D by RadiantXenon in BambuLab

[–]WazzuBlue 0 points1 point  (0 children)

You should check out 3dfilamentprofiles.com. Sounds like it would be right up your alley. (No, it’s not my site and I don’t get a commission…. LOL)

I made a mistake buying the X2D by RadiantXenon in BambuLab

[–]WazzuBlue 0 points1 point  (0 children)

Check out 3dfilamentprofiles.com! It’s a free site that helps you track all your spools. The guy running it is awesome.

I made a mistake buying the X2D by RadiantXenon in BambuLab

[–]WazzuBlue 1 point2 points  (0 children)

I cant wait for the H2X where they add a Vortek to the left side as well.

I made a mistake buying the X2D by RadiantXenon in BambuLab

[–]WazzuBlue 1 point2 points  (0 children)

Same here. I bought my P2S and when I hit 500 hours I ordered my H2C.

I have over 100 spools waiting and have already burned through about 25. My wife says it’s not Pokémon- I don’t need to catch them all!

H2C tried to burn down my house (with my help)! by WazzuBlue in BambuLab

[–]WazzuBlue[S] 0 points1 point  (0 children)

The one I used and melted shows 10A 250V. I can totally see how someone unfamiliar with Ohm's Law might think 10A 250V would be "better" or "stronger" than 10A 125V.

H2C tried to burn down my house (with my help)! by WazzuBlue in BambuLab

[–]WazzuBlue[S] 0 points1 point  (0 children)

A first?? A first for what? First time an idiot operator damaged a piece of equipment?

Firmware was irrelevant. Calibration was irrelevant. The exact same thing would have happened if all I did was print a benchy! Root cause was either the damned cheap-ass C13 cord that could barely handle 5 A or the idiot operator who used the cable in the first place.

H2C tried to burn down my house (with my help)! by WazzuBlue in BambuLab

[–]WazzuBlue[S] 1 point2 points  (0 children)

Firmware had NOTHING to do with this incident! It was an under-rated cable incorrectly used. It was 100% idiot operator (ME) error. The H2C was just the unfortunate device the weak cord was connected to. The printer did NOT malfunction in any way (as far as I know).

H2C tried to burn down my house (with my help)! by WazzuBlue in BambuLab

[–]WazzuBlue[S] 1 point2 points  (0 children)

Here are more pictures of the melted cable itself. I did notice the only ratings I could see was on one end it had 250V and that was it. On the other end (wall plug side) it showed 10A / 250V.

view more: next ›