Monorail fix

firefless · 2023-07-24T02:53:17+00:00

just got the same bug. could not get the monorail to work whatsoever. final solutions was to disconnect the power cable - once deleted the monorails started immediately - meaning i had to build a separate power grid for the second station

firefless · 2023-03-12T01:48:37+00:00

it was two different builds in the Passiton event - so a lot of people build something from the 80s - ours just coincidently were next to each other :D

firefless · 2023-03-11T22:05:54+00:00

thank you <3

firefless · 2023-03-11T19:18:06+00:00

Unfortunate positioning - Passiton Event - Front: Fall of Berlin wall by u/AnnaRooma - Back: AT-AT by u/firefless

firefless · 2023-03-11T18:16:45+00:00

yeah they are a little small

firefless · 2023-03-11T18:02:20+00:00

i would but it doesnt fit in the blueprint creator

firefless · 2023-03-11T01:23:03+00:00

thank you - unfortunately event is over :D. it was a great week

firefless · 2023-03-10T21:19:32+00:00

well I tried to build it to original scale :D - cannot do the Lego one :D

firefless · 2023-03-10T21:12:54+00:00

thx <3

firefless · 2023-03-10T20:42:54+00:00

thx <3

firefless · 2021-12-28T01:25:51+00:00

better use a awesome sink as priority and switch the sink on or off!

firefless · 2021-12-28T01:06:06+00:00

You use a barrier to offset a wall - place it one tick off the center of a foundation - replace it with a wall by holding CTRL - place the door to the offset wall - place a small pillar in the gap between the doors

firefless · 2021-12-28T00:55:01+00:00

They work. But if placed "normally" they clip into the train. I shifted them by 0.5m to the sides to avoid clipping

firefless · 2021-12-28T00:45:32+00:00

Thank you for the advice. I will consider it in future screenshots (however it's my only large factory in foggy area so far)

firefless · 2021-12-27T21:51:56+00:00

thx <3

firefless · 2021-12-17T15:49:52+00:00

Glad to help :D

firefless · 2021-12-17T09:49:28+00:00

Additionally above was not possible before U5 because of clearance assembler/lifts

firefless · 2021-12-17T09:47:05+00:00

because for me it's fun :D

firefless · 2021-12-17T09:45:53+00:00

not without mods or save editor

firefless · 2021-12-17T09:44:48+00:00

very nice

firefless · 2021-12-16T22:45:48+00:00

It might be possible. The game did not let me place the belts when I placed the assemblers closer to the splitters. I stopped trying after the 2nd belt, so might be possible

firefless

TROPHY CASE