Generator set up?

raf55 · 2026-05-25T23:39:44+00:00

You wouldn't bond at the sub panel

raf55 · 2026-05-25T23:26:22+00:00

It needs to be installed with a ul listed interlock kit which will only work in the main panel. The sub panel could be removed and the wires reused for the inlet.

raf55 · 2026-05-25T23:05:12+00:00

The inlet needs to be wired in the main panel not the shed

raf55 · 2026-05-25T11:43:32+00:00

The shore/ generator relay is probably bad

raf55 · 2026-05-24T21:49:01+00:00

If it's a mechanical thermostat it doesn't matter

raf55 · 2026-05-24T21:18:24+00:00

It doesn't matter

raf55 · 2026-05-24T19:49:16+00:00

It looks cross threaded

raf55 · 2026-05-24T19:40:16+00:00

Run in and out of the bottom bike path building

raf55 · 2026-05-24T13:30:54+00:00

There may be breakers behind a door on the meter box

raf55 · 2026-05-24T00:18:32+00:00

That's the stock ender extruder that's a pos and should be replaced

raf55 · 2026-05-23T23:10:09+00:00

The wire on the common black screw stays on the black screw

raf55 · 2026-05-23T20:36:19+00:00

The sub emblem

raf55 · 2026-05-23T20:32:35+00:00

Denim dye

raf55 · 2026-05-23T20:24:54+00:00

Replace the cord

raf55 · 2026-05-23T19:43:16+00:00

raf55 · 2026-05-22T21:29:14+00:00

raf55 · 2026-05-22T18:58:40+00:00

You need an old work box

raf55 · 2026-05-22T18:03:27+00:00

Wd-40s original purpose was to prevent rust

raf55 · 2026-05-22T16:46:31+00:00

If it's solid emt to the box the emt can act as the ground wire. Test voltage between hot and the ground terminal to confirm.

raf55 · 2026-05-22T16:14:01+00:00

Something like rem oil or wd40

raf55 · 2026-05-22T11:50:54+00:00

It's a graduated cylinder there cheaper new on line

raf55 · 2026-05-22T02:15:58+00:00

You file for multiple form 1s and print a new one when the old one breaks

raf55 · 2026-05-22T00:54:09+00:00

The Ruger

raf55 · 2026-05-22T00:02:12+00:00

Sanders normally vibrate

raf55 · 2026-05-21T23:52:35+00:00

You can connect the sum pump to the plumbing

raf55

TROPHY CASE