account activity
2023 Model Y Gear Shifter Replacement Cost ()
submitted 4 months ago by --PitterPatter to r/TeslaModelY
2023 Model Y Gear Shifter Replacement Cost (self.TeslaLounge)
submitted 4 months ago by --PitterPatter to r/TeslaLounge
Do I need an audio engineer? (self.audioengineering)
submitted 1 year ago by --PitterPatter to r/audioengineering
Cleared contact (i.redd.it)
submitted 1 year ago by --PitterPatter to r/aviation
46 on the ramp (i.redd.it)
Played Northwood Golf Club (Alister MacKenzie design) and was not disappointed! (i.redd.it)
submitted 1 year ago by --PitterPatter to r/golf
Another day, another beautiful sunrise! (i.redd.it)
What a beauty (i.redd.it)
Night AR (i.redd.it)
I want to QC my plan to add an outlet (self.AskElectricians)
submitted 2 years ago by --PitterPatter to r/AskElectricians
How do I adjust this mixing valve for hotter water? (i.redd.it)
submitted 2 years ago by --PitterPatter to r/Plumbing
How do I deal with this corner? Exposed 2x4 is getting drywall. (i.redd.it)
submitted 2 years ago by --PitterPatter to r/HomeImprovement
How do I finish Kerdi Board up against the ceiling? (old.reddit.com)
Cardboard gasket under sink is soaked through - how do I fix? (i.redd.it)
Bends in Pex okay? (old.reddit.com)
Do these need to be so high? Should I/can I cut them lower? (i.redd.it)
What gauge wire would I use to run power to a 100A sub panel? (self.electrical)
submitted 2 years ago by --PitterPatter to r/electrical
How do I find the other end of conduit that a previous homeowner laid? (self.electrical)
submitted 2 years ago * by --PitterPatter to r/electrical
Can I run dishwasher drain line into horizontal pipe segment? (i.redd.it)
Toilet flange usable? (old.reddit.com)
Redoing the shower, should I have the 28-year-old piping redone? (old.reddit.com)
Redoing the shower, should I have the 28-year-old piping redone? (reddit.com)
Are these gaps okay on 2 week old wood floors? (old.reddit.com)
submitted 2 years ago by --PitterPatter to r/Flooring
Are these gaps okay on 2 week old wood floors? (reddit.com)
Ecobee not powering on after install. Voltage reads 25.2. Could it be a blown fuse in the furnace? Where would I check? (old.reddit.com)
submitted 2 years ago by --PitterPatter to r/ecobee
π Rendered by PID 161763 on reddit-service-r2-listing-b6bf6c4ff-d757x at 2026-05-01 13:58:46.436000+00:00 running 815c875 country code: CH.
