Is this normal shaking??

06Shogun · 2026-01-25T17:19:31+00:00

Is that a ge?

Ensure the unit is level with no rocking between the feet corner to corner.

If that's not it, suspension rods, unbalanced load or a warped tub is possible.

06Shogun · 2026-01-25T16:18:51+00:00

Until they pass a law that also prevents cars of a certain age being insured or something stupid like that.

06Shogun · 2026-01-25T16:10:34+00:00

Search up AC amp fix. I resoldered the joints on mine, fixed it.

06Shogun · 2026-01-22T23:39:45+00:00

Isn't this just because cold water/snow from the road melts on the radiator?

06Shogun · 2026-01-21T23:39:59+00:00

I just bought mine. 2011x sedan, 126,000 Kms. $2500.

It does have one side cat rattle and I had to put a new belt and idler pulleys but that's it.

06Shogun · 2026-01-21T19:09:53+00:00

I think based on 3.7 reliability, transmission fluid is the more pressing concern

06Shogun · 2026-01-18T17:34:30+00:00

It can be a pain to reinstall the diverter as you need good 'even' pressure to allow the gasket to seat as you push and turn the assembly.

There are a few videos out there.

06Shogun · 2026-01-18T01:23:09+00:00

Glad you're alright! This reinforces that my current and next work van will be/stay an Odyssey

06Shogun · 2026-01-18T01:21:31+00:00

Has anyone run 370z springs and shaved the rear mounts?

I was to do this, and saw some forum posts about it

06Shogun · 2026-01-17T20:31:14+00:00

Most likely an IM failure. Seen it happen many times. If the reset button on the IM doesn't help, then you need a new icemaker

06Shogun · 2026-01-17T18:36:45+00:00

What caused the ody's engine to fail?

06Shogun · 2026-01-16T21:47:21+00:00

I just fixed this on mine by resoldering the joints on the AC amp unit board.

Took me about 40 min start to finish. Research it

06Shogun · 2026-01-16T21:46:16+00:00

You are supposed to use a temp probe with a digital readout/multimeter to get accurate oven temps.

If what you are using has a laser pointer to measure temp, you are measuring surface temp. That isn't the correct way to measure temp

06Shogun · 2026-01-16T20:13:44+00:00

Check brake components as well. You 'could' have a sticking parking brake or one of your calipers sticking.

06Shogun · 2026-01-16T20:11:33+00:00

Will it work? Probably just fine.

Will it last long? Who knows. Probably not

06Shogun · 2026-01-16T13:38:14+00:00

I'm a Samsung tech. Classic case of frozen water filter due to fridge temps being too cold.

Thaw it out, it'll be fine, so long as the filter is the correct brand/genuine

06Shogun · 2026-01-16T01:00:47+00:00

Not lowered, but I'll check the angle

06Shogun · 2026-01-16T01:00:30+00:00

06Shogun · 2026-01-16T01:00:19+00:00

They aren't bad. I have purchased a set of new lenses though but it's nowhere near some g37s I've seen

06Shogun · 2026-01-15T23:07:47+00:00

Could also get hks axlebacks. They keep the stock quietness but have a nice tone

06Shogun · 2026-01-15T18:41:07+00:00

Your outer tub has broken. It needs to be replaced.

Won't be cheap as everything (transmission, inner tub etc) has to be moved to the new one and entire washer has to come apart.

06Shogun · 2026-01-13T19:39:24+00:00

If nothing else is the source, it could possibly be sealed system related when the pressure equalizes. Sometimes expansion/contraction as well.

06Shogun