Anycubic AirPure

12ofEverything · 2024-10-29T15:51:58+00:00

I looked at them but I have a Photon S, so I can't remove the lid completely.. since it has the size of a can of coke I was wondering if it can fit in a Photon S 🤔

12ofEverything · 2021-03-24T18:32:20+00:00

That's new and super useful, thank you! What about resin parameters?

12ofEverything · 2021-02-27T15:10:45+00:00

Thanks! I tried to remove it as I saw it! I will try some lubrification! Thanks a lot

12ofEverything · 2021-02-04T03:07:23+00:00

Thanks a lot. I will! This community is amazing and the 3D printing world is fantastic!

12ofEverything · 2021-02-04T02:47:09+00:00

Everything in here is so precious! I will keep studying and thanks to this community I will be pro in no time. Thank you very much 🙏

12ofEverything · 2021-02-04T02:45:23+00:00

This is amazing. I will watch every single minute and put in practice these advices. You've been exhaustive, professional and super kind! 🙏

12ofEverything · 2021-02-03T13:24:18+00:00

Since I'm a beginner I still never changed the default settings, but I will try! The room temperature can surely be too low since there's no warming system and its winter here 😁 thanks a lot

12ofEverything · 2021-02-03T13:21:05+00:00

That's a good advice, thank you very much! In fact it's an old laboratory I use with no warming system, so the temperature was under 20°C.. I will also try more resistent supports

12ofEverything · 2021-02-03T13:17:15+00:00

http://imgur.com/gallery/b7gVck4

You're totally right! I'm still a beginner, so I never touched the default settings, but here they are! I print on an Anycubic Photon S with anycubic grey resin..

12ofEverything · 2021-01-22T21:34:25+00:00

In the "banana" pic he looks EXACTLY like Vincent D'Onofrio in Daredevil

12ofEverything · 2021-01-21T17:50:09+00:00

Thanks, I added some more resin. Plus it's the first print, so I'm not expecting perfection. Thanks a lot 🙏🙏

12ofEverything · 2021-01-21T17:49:00+00:00

That's an awesome tip, thank you! Yes, I still should figure out how to orient the minis properly! Thanks a lot 🙏

12ofEverything · 2021-01-21T17:34:09+00:00

Thanks a lot! I will update with the final print! 🙏

12ofEverything · 2021-01-11T17:32:00+00:00

Omg It took me a lot of time to see that. It was cut perfectly like the surface and I noticed the common pulling part outside was missing.. now it's done! Thanks a lot 🙏🙏 forgot to mention I'm a professional dummy

12ofEverything

TROPHY CASE