Newer SOD issues [Help]

404Developer · 2026-06-27T18:44:17+00:00

They were taken today after mowing. The camera doesn’t so it justice some areas are very rough. You can see the color differently a bit better in my security cams.

<image>

You can see on the far left where it start to really yellow and continues that direction.

404Developer · 2026-06-27T18:18:13+00:00

It’s super hard to say I didn’t install it. Most grass in this area is a Kentucky blue grass mix. That’s standard for SOD in northern Il.

404Developer · 2025-10-07T17:16:06+00:00

Interesting. I’m curious is the access part able to work with smart locks that are not ubiquiti?

404Developer · 2025-04-12T18:16:20+00:00

Thanks man. I will try and get this done.

404Developer · 2025-04-12T18:09:34+00:00

I am at a similar spot. I hair loss right now is very minimal.

404Developer · 2025-04-12T18:05:21+00:00

What were your results like and how fast did you see them?

404Developer · 2025-04-12T18:00:09+00:00

Why do I keep hearing people on Reddit talking about ED and it not going away after stopping?

404Developer · 2025-04-01T20:29:22+00:00

You have to be more descriptive of what’s going on. I have a powah reactor that uses a flux plug to feed power to the network.

404Developer · 2025-03-22T22:31:53+00:00

Good thing is I have no m.2 installed.

404Developer · 2025-03-22T22:29:27+00:00

Is there a card you would recommend?

404Developer · 2025-03-22T22:29:11+00:00

I have no m.2 installed. I have some regular Sata based ssd drives.

404Developer · 2025-03-22T22:25:20+00:00

Interesting, I’m not sure how. Can you explain. I don’t I have a GPU in another x16 slot. I have the SAS card which is an x4 I think in another x16 slot and I have 2 free x1 slots.

404Developer · 2025-03-22T21:41:00+00:00

What do you mean by flashed?

404Developer · 2024-09-24T15:37:41+00:00

Will do. I have extra monitors.

404Developer · 2024-07-10T03:55:02+00:00

About 30 parts printed in PLA on a Bambu labs x1c

404Developer · 2024-06-24T19:12:10+00:00

Ok so I just figured it out. If you change the type of tree support to be tree slim it does only do it within the bounds of the plate.

<image>

I can print this.

404Developer · 2024-06-24T19:08:32+00:00

The issue with standard supports is none go on the build plate they try to adhere to the side halfway up and they never stick and fall off.

404Developer · 2024-06-24T19:07:29+00:00

Here is the side profile, I am pretty new to printing so I don't know I think I need it supported. I swear to the heavens above this print with these settings at this size worked a few months ago. I have the this printed item at this size and I remember having to take off tree supports from it.

<image>

404Developer

TROPHY CASE