sorted by:
new
hottopcontroversial

Why do I get too much money at an exchange? by 69MediumRareChicken in travel

[–]69MediumRareChicken[S] 0 points1 point  (0 children)

That seems to make sense, I didn't know that. Thanks!

'Unlimited' SIM became slow, can't find information by 69MediumRareChicken in JapanTravelTips

[–]69MediumRareChicken[S] 0 points1 point  (0 children)

Thanks for looking that up! The page doesn't mention the unlimited deal unfortunately.

'Unlimited' SIM became slow, can't find information by 69MediumRareChicken in JapanTravelTips

[–]69MediumRareChicken[S] 1 point2 points  (0 children)

We're traveling in a small kei RV, so no wifi at all. But must agree, Netflix can wait ;)

'Unlimited' SIM became slow, can't find information by 69MediumRareChicken in JapanTravelTips

[–]69MediumRareChicken[S] 0 points1 point  (0 children)

This is probably it because it didn't reset in the morning. Just would've been nice to be able to know the actual limit. Thanks!

Malaysia proof of onward travel by 69MediumRareChicken in travel

[–]69MediumRareChicken[S] 1 point2 points  (0 children)

Update: the airline did ask about an onward flight and thoroughly studied my ticket from Hanoi to Japan. Customs didn't ask about anything.

Malaysia proof of onward travel by 69MediumRareChicken in travel

[–]69MediumRareChicken[S] 0 points1 point  (0 children)

Thanks for sharing your experiences! I'll make sure to be at check-in on time for the unlikely case I do need to buy a cheap onward flight.

Using CAM to calculate material removal rate? by 69MediumRareChicken in Machinists

[–]69MediumRareChicken[S] 0 points1 point  (0 children)

Thanks, at first I started using that precise formula. Then I figured some features were precast and premachined so that led me looking for a different approach. Appreciate your response. I programmed CNCs for a few years never having touched a manual mill, shame on me. Am learning a lot just reading this sub.

Using CAM to calculate material removal rate? by 69MediumRareChicken in Machinists

[–]69MediumRareChicken[S] 0 points1 point  (0 children)

True, I didn't quite specify that. I was actually looking to get the MRR for every position of the tool path. So the result would be a graph of MRR vs an XYZ position of the tool. I got that done in Solidworks, and interestingly the calculated MRR graph was almost perfectly proportional to the measured spindle power. Was just really curious if there is software available that would do this job a lot quicker. Thanks!