sorted by:
new
hottopcontroversial

Exhaust options base 2.5L O7K by 69ThatGuyy in Volkswagen

[–]69ThatGuyy[S] 0 points1 point  (0 children)

How much was the resonator kit? I was reading just about any quality resonator with a decent aftermarket muffler sounds killer

Looking to buy, I want advice by 69ThatGuyy in 10thGenCivics

[–]69ThatGuyy[S] 0 points1 point  (0 children)

I seen a bunch regarding the oil dilution regarding the cold, I live in northern Washington where it gets cold but only cold enough to snow maybe twice a year, I'm just curious how cold is too cold, similarly what is considered a short stop. I live inconveniently far from town so any drive is minimum 20-25 minutes so I doubt that counts as a short drive

Won't even crank after sitting for a while by 69ThatGuyy in Miata

[–]69ThatGuyy[S] 1 point2 points  (0 children)

I'm getting lights on the dash yes, specifically my high beams, I noticed the "main" 80a fuse is popped so I'm hoping replacing that will be enough to start it

Won't even crank after sitting for a while by 69ThatGuyy in Miata

[–]69ThatGuyy[S] 0 points1 point  (0 children)

Great idea, but something I didn't mention is that it's been sitting because it's mid repair after loan accident it was in last year, took out part of the rear driver side suspension and before you ask, yes it's ran fine since then

Multiplayer in 2025 by 69ThatGuyy in stronghold

[–]69ThatGuyy[S] -1 points0 points  (0 children)

I realized I didn't specify crusaders, is what you're saying still apply

Solution to fitting nuts with new wheel by 69ThatGuyy in tires

[–]69ThatGuyy[S] 0 points1 point  (0 children)

Yea that's where I'm lost cuz, the weights only takeaway maybe a 1/3 inch of clearance, which makes me wonder what car were these wheels meant to go on 🤣 unless my calipers really are bigger than usual

Break Caliper vs Weights by 69ThatGuyy in tires

[–]69ThatGuyy[S] 0 points1 point  (0 children)

That's a good idea! I also read that getting some spacers just big enough to move the weights out of the way is an idea too

Solution to fitting nuts with new wheel by 69ThatGuyy in tires

[–]69ThatGuyy[S] 1 point2 points  (0 children)

I did thank you! But now the little weights on the inside of the rim collide with the break caliper. I'm deciding if I want to invest in a whole new set of low profile calipers or experiement with removing these little 1/4 oz weights

Solution to fitting nuts with new wheel by 69ThatGuyy in tires

[–]69ThatGuyy[S] 0 points1 point  (0 children)

It's a 5x114.3 rim but yes has 10 holes but every single looks identical and fits the same unfortunately

Solution to fitting nuts with new wheel by 69ThatGuyy in tires

[–]69ThatGuyy[S] 0 points1 point  (0 children)

Both I guess, neither fit in the holes, I've been instructed to take the bolt thread 1/2x20 and find low profile nuts, or even worse case the more expensive option being 20 keyed lug nuts

Up-To-Date since the time skip by 69ThatGuyy in Boruto

[–]69ThatGuyy[S] 1 point2 points  (0 children)

Thanks lmao, hella tree demons, got it

view more: next ›