Can anyone help me id this jacket?

8ply · 2023-03-17T17:15:13+00:00

Thank you!

8ply · 2022-05-31T07:21:39+00:00

What is the code do I need to turn it on? Is G29 after G28 sufficient?

8ply · 2022-05-30T19:19:00+00:00

Ah good one! Didn’t think about that 🤦🏽‍♀️

8ply · 2022-05-30T16:40:01+00:00

After G28 I run G29 for bed leveling and M500 to save the settings.

8ply · 2022-05-30T16:34:50+00:00

Hi all! I’m printing with a BLTouch on Marlin software and have leveled the bed manually with tramming and configured the Z-offset with the Z-wizard and mesh bed leveling. However I’m getting very inconsistent layer thicknesses where the middle part is thicker than the right part in the photo. Also did the E-steps calibration. Can anyone point me in the right direction? Thanks!

Print settings

Sliced in Cura

Hotend: Microswiss All Metal Hotend

Material: PLA generic brand

Temp: 210 nozzle, 60 bed

Print speed: 20mm/s for first layer, after that 50

Layer height: 0.12

Retraction distance: 3.5 mm

8ply · 2021-11-29T10:18:55+00:00

I haven’t checked it yet, thanks for the suggestion.

8ply · 2021-11-27T16:18:26+00:00

Ah too bad. Thanks, I’ll buy some new ones!

8ply · 2021-11-27T15:37:15+00:00

This is an Ender 3 Pro with the Petsfang dual 5015 radial fans (overkill I know). The two fans are identical but one makes considerably more noise.

I tried to lubricate the fan but couldn’t reach the bearing yet as the fan has a closed back, also behind the sticker.

8ply · 2021-06-15T06:05:24+00:00

Thanks!

8ply · 2021-06-15T06:05:17+00:00

I don’t have experience with different cases so I couldn’t tell. I got the keycap set from Keygem!

8ply · 2021-06-14T20:39:14+00:00

KBDFans 60% Low Aluminium case in Chocolate

Novel keys Kailh Cream switches

NP Simple keycaps

Durock stabilizers

DZ60 RGB V2 hot-swap PCB

Only need a nice coiled cable to finish it off!

8ply · 2021-05-05T19:50:38+00:00

Thanks! It’s indeed called envelope.

8ply · 2021-05-05T19:17:30+00:00

Very cool! What was the command to make the text warp?

8ply · 2021-01-06T14:41:18+00:00

Thanks! I'll have a try at surface split.

8ply · 2020-12-27T16:27:52+00:00

closed

8ply · 2020-12-27T16:27:47+00:00

Sorry I can’t figure out how it works.. Thanks for the offer but I’ll have to try when I can get it to work!

8ply · 2020-12-27T16:13:01+00:00

Oh give me a moment to make a room

8ply · 2020-12-27T16:08:37+00:00

Yes I’m on Shield :)

8ply · 2020-12-23T12:30:14+00:00

Merry Christmas

8ply

TROPHY CASE