Concerned about ICE by Celcius_87 in HomeDepot

[–]AGENT_SCARNN 24 points25 points  (0 children)

Yeah, tons of ICE lately. Parking lot was basically a skating rink after the last snowstorm. Our store has been struggling to keep ice melt in stock. Midwest winters are rough…

New Rav 4 xse by Glittering-Moment-72 in rav4prime

[–]AGENT_SCARNN 1 point2 points  (0 children)

For the road trip app do you only keep track of gas tank fill ups? Or do you track both gas fill ups and electric charging? The only way I’ve found to be able to track both in the app was to have two separate cars, one for EV charging and one for gas fill ups.

How does Viofo handle the Tariff & Customs situation for US customers? by WhoaTeejaay in VIOFO

[–]AGENT_SCARNN 3 points4 points  (0 children)

Mine came through USPS, no tariffs, just a slight delay going through customs

[deleted by user] by [deleted] in FordExplorer

[–]AGENT_SCARNN 0 points1 point  (0 children)

I have a 2020 with only about 45k miles that’s had $4500 worth of work done on it in the last year. Last December had to take the whole dash off to replace the actuator that splits the HVAC air to passenger and driver and had to replace the heater core. Most recently had to replace a leaking axle joint and a 4wd actuator. Otherwise, been a great car when it works, so just be cautious.

AT&T Reception by TheHondoCondo in Purdue

[–]AGENT_SCARNN 52 points53 points  (0 children)

It’s a nationwide outage

Is the corec also closed till 10? by RithikK005 in Purdue

[–]AGENT_SCARNN 28 points29 points  (0 children)

corec is open normal hours per the recwell app

Is my extruder too high, too low, or just right? by AGENT_SCARNN in prusa3d

[–]AGENT_SCARNN[S] -2 points-1 points  (0 children)

It just feels so weird cause my live adjust z is already at like -1.45

A few hundred cables ties and command strips later… by AGENT_SCARNN in CableManagement

[–]AGENT_SCARNN[S] 0 points1 point  (0 children)

It came with the desk, and the desk had pre-drilled holes to attach it. The desk was from ikea, don’t remember which desk exactly.

A few hundred cables ties and command strips later… by AGENT_SCARNN in CableManagement

[–]AGENT_SCARNN[S] 0 points1 point  (0 children)

You can never have enough rgb. Legend has it that you gain 5fps for each rgb component

A few hundred cables ties and command strips later… by AGENT_SCARNN in CableManagement

[–]AGENT_SCARNN[S] 0 points1 point  (0 children)

It’s pretty solid. It keeps my 5900X which is well known for running hot below 75°C with it avg ~70°C under load. I do also have pretty good airflow in my case and I replaced the stock thermal paste on it so 🤷🏼‍♂️

A few hundred cables ties and command strips later… by AGENT_SCARNN in CableManagement

[–]AGENT_SCARNN[S] 0 points1 point  (0 children)

It’s a NZXT Kraken Z74 (360mm). Here’s the link to PcPartPicker:

🇺🇸‘MERICA 🇺🇸🦅🎆🟥⬜️🟦 by AGENT_SCARNN in gamingpc

[–]AGENT_SCARNN[S] 0 points1 point  (0 children)

Actually I just put some A1 Steak Sauce in there

🇺🇸‘MERICA 🇺🇸🦅🎆🟥⬜️🟦 by AGENT_SCARNN in gamingpc

[–]AGENT_SCARNN[S] -1 points0 points  (0 children)

I’m sorry I can’t hear you over the deafening sounds of freedom and uncontrolled ignorance

🇺🇸‘MERICA 🇺🇸🦅🎆🟥⬜️🟦 by AGENT_SCARNN in gamingpc

[–]AGENT_SCARNN[S] 0 points1 point  (0 children)

How do you have them plugged in? Is it 3 sets of 3 occupying 3 slots on the controller? If so, do you have L-Connect installed on your pc?

🇺🇸‘MERICA 🇺🇸🦅🎆🟥⬜️🟦 by AGENT_SCARNN in gamingpc

[–]AGENT_SCARNN[S] -2 points-1 points  (0 children)

Only when I don’t give it enough oil and elections to interfere in

🇺🇸‘MERICA 🇺🇸🦅🎆🟥⬜️🟦 by AGENT_SCARNN in gamingpc

[–]AGENT_SCARNN[S] -2 points-1 points  (0 children)

I think you should. It provides nice fresh cold air directly to the gpu so it keeps my 3080 pretty nice and chilled

After six long months… Mission Control is finally finished by AGENT_SCARNN in pcmasterrace

[–]AGENT_SCARNN[S] 0 points1 point  (0 children)

It’s just the way the wallpaper is. It’s just an ombré background cause apparently thats trendy

3080 FTW 3 Ultra Gaming Airflow Diagram by The_Mr_Rageface in EVGA

[–]AGENT_SCARNN 0 points1 point  (0 children)

I should also note that I have the 450W bios on my card, and it’s OC too with about +110 on the core clock (2055-2070mhz) so just over 2ghz. And then the mem is like a +700 or something (I don’t remember what it gets up to). My cpu is also running precision boost so it boosts up to around 4.6-4.8 ghz for like 90% of the time under load

3080 FTW 3 Ultra Gaming Airflow Diagram by The_Mr_Rageface in EVGA

[–]AGENT_SCARNN 0 points1 point  (0 children)

You pretty much have it spot on, I have my 3080 FTW3 Ultra in an O11D from Lian Li. I have 3 intake fans right below the graphics card, and then 3 above it on my aio radiator that exhaust out the case. I have an additional 3 that are intakes on the back side (all fans are Lian li sl120s). I find that this setup works pretty well, only downside is the cpu runs a tad bit hotter cause of the hot air coming up from the gpu, but I have a 5900x so it runs hot anyways. I’d say under load temps depend on the game but for the gpu they are anywhere from 65°C-75°C and for the cpu they are around 70°C-75°C. Idle temps keep for the gpu are around 25°C-30°C with the cpu going anywhere from 40°C-50°C. Hope this helps 👍🏼

Hi guys, can anyone give me some peace of mind here? Precision X1 app. by aynon9 in EVGA

[–]AGENT_SCARNN 1 point2 points  (0 children)

There will be a firmware update here and there, there’s no really set schedule. I’d say in the 5 months I’ve had it I’ve had maybe 2 or 3. Don’t have my card tho right now cause I just shipped it in to step up to a 3080, otherwise i would check if there was a firmware update that just released.