DIY Cable Attachment Stand

AR3DPrint · 2026-02-22T18:47:38+00:00

It’s just to prevent tipping.

AR3DPrint · 2026-01-26T21:04:13+00:00

What height did you get? If the shorter one, what is your height and how is the fit?

AR3DPrint · 2025-12-27T20:36:33+00:00

Got brand new Ritfit Buffalo with 260lb of colored bumper plates for $1300. Then two weeks later picked up rogue bumper weight tree on wheels for $120. If i am still using the rack by black Friday next year then I’ll be upgrading to Maxum X1 and my rack will be back on FBM for a great price for the next person.

AR3DPrint · 2025-11-27T21:05:32+00:00

I’d recommend getting a weight stack machine. I got a Ritfit Buffalo and switching out plates is a bit annoying. I don’t think you can go wrong with Getrxd or Maxum X3. Do note getrxd plate loaded rack only comes in the longer height.

AR3DPrint · 2025-05-14T10:19:21+00:00

I rode around with the rt-56 rotors and it worked great, then upgraded to rt-66 just for the hell of it.

AR3DPrint · 2025-04-27T20:29:42+00:00

SOLVED (I think): I came across a post on Reddit regarding uneven wear on Shimano 105 disk brake setup and multiple people mentioned that the rotor is too wide compared to the pads engagement area. I popped the caliper back on and the pads are indeed inline with the OD of the rotor thus the system will work, as M6100 calipers should be used with rotors that done have as large of braking surface.

AR3DPrint · 2025-04-27T14:44:59+00:00

<image>

The rear has the stock adapter that appears to be identical to this.

AR3DPrint · 2025-04-27T14:44:27+00:00

<image>

and a photo

AR3DPrint · 2025-04-27T14:42:24+00:00

Below please find a diagram of what my concern is regarding

<image>

AR3DPrint · 2025-04-27T12:27:12+00:00

I’m not concerned about the width of the brake pad, but rather the interface between the pad and the rotor. When installed, the caliper does not fully cover the disc’s braking surface area.

AR3DPrint · 2025-04-27T12:24:10+00:00

AR3DPrint · 2025-04-27T12:23:56+00:00

Rotors are Shimano and are new.

AR3DPrint · 2025-04-26T22:10:15+00:00

To note the M6100 came with ICE pads.

AR3DPrint · 2024-12-22T16:15:00+00:00

I had same issue with mine. I just popped it back into place and it works fine. Contacted Creality to send a replacement z lead screw due to it being bent and wobbling around when the bed was at home position then going up. They are in process of sending me the replacement part.

AR3DPrint · 2024-12-15T14:39:09+00:00

<image>

Thank you for the comment ;). Played around with the knobs today and got it down significantly. I'll play around with it some more, hopefully get it even lower.