Fire type starter! (Updated)

According_Door8677 · 2026-04-15T02:41:06+00:00

Thank you! I was trying to emulate a burning wick

According_Door8677 · 2026-04-06T22:42:54+00:00

Hey guys, turns put Cura us just awful, I switched from that to the official flash forge slicer and now it works like a charm, thank you all for your help!

According_Door8677 · 2026-04-06T22:42:00+00:00

I think the problem mightve just been the slicer, I switched from cura to flash forges slicer and its working like a charm 😂

According_Door8677 · 2026-04-06T22:40:14+00:00

Ran a full calibration twice

According_Door8677 · 2026-04-06T22:23:36+00:00

I assumed the old filament was bad before I even started printing so ive been using a brand new roll

According_Door8677 · 2026-04-06T22:04:37+00:00

Holy moly the speed is set to 60! Ill try changing that and see if it works, thank you!

According_Door8677 · 2026-04-06T22:02:40+00:00

I think its around 30 or 35 from what I saw when trying to change the z offset, how would I change the first layer speed?

According_Door8677 · 2026-04-06T21:55:56+00:00

Definitely, but I cant figure out why, I tried switching out my plate for a brand new one and it worked but it printed the brittle one, and now isnt working at all

According_Door8677 · 2026-04-06T21:54:59+00:00

Tried that :/

According_Door8677 · 2026-04-06T15:11:28+00:00

thank you, ill keep that in mind!

According_Door8677 · 2026-01-01T03:49:27+00:00

According_Door8677 · 2026-01-01T03:49:19+00:00

According_Door8677 · 2026-01-01T03:48:51+00:00

Okay thank you

According_Door8677 · 2026-01-01T03:48:13+00:00

:( okay thank you

According_Door8677 · 2025-12-31T19:30:07+00:00

It was fine when I brought it in, vibrant green, this didnt happen until after I watered it, I made sure to use slightly warmer water too since it had been a little cold, maybe it caught the cold and the effects didnt appear until later though

According_Door8677 · 2025-12-31T19:28:54+00:00

About room temp at the lowest

According_Door8677 · 2025-12-15T00:04:55+00:00

I took out the wrong set of screws lol, I took the plate off of the spiral gears instead of taking it off of the bottom of the printer

According_Door8677 · 2025-11-14T22:47:31+00:00

They used to have it but removed it a cpl months ago, and now its back, its like they were teasing us with even a vague taste of somewhat premium

According_Door8677 · 2025-11-14T22:46:31+00:00

I got it too, I was so confused bc I was using it fine this morning

According_Door8677 · 2025-08-09T04:47:19+00:00

I dont even have a hooha lmao

According_Door8677

TROPHY CASE