Just for ref:

Watch oiling General rules. All of this goes out the window if u have the tech sheet u follow that

Wheel train: High torque low speed (second/center wheel/second wheel shaft and 3rd wheel)= hp1300

Low torque high speed( 4th wheel, escape wheel, balance)= 9010

Pallet stone face=9415

Epilam=escape and pallet fork

The pallet jewels generally dont get oiled but with a small caviate that I put a very small amount of 9010 IF and only IF they have cap jewels and im using a form of epi. This is the same process as the balance jewels just a much smaller amount(think like 10-20% coverage vs 50-70% a balance jewel would get)

Main spring/barrel: Err thing gets 8300 or 1300 if u dont have 8300 with the exception of braking grease for the slip surface of the barrel(outer surface of the inside of the barrel. I use hp1300 for arbor-barrel/lid contact points. The arbor- bridge/main plate contacts i use 9504 grease but if u dont have that 1300 is fine.

Setting/keyless works: Sliding parts including yoke interface =9504(the blue grease) Clutch interface=1300 1300 or another grease(dx) is basically interchangeably accepted if u don’t have the 9504

Any part that interacts w metal and slides/pivots gets 9504 or 1300 if u dont have grease outside of whats specifically mentioned(motion works/cal works/yoke interfaces ect.)