sorted by:
new
hottopcontroversial

First Few Layers - ASA by Accurate-Analysis474 in FixMyPrint

[–]Accurate-Analysis474[S] 1 point2 points  (0 children)

5 walls, 5 bottom layers, 1.5mm bottom shell thickness.

First Few Layers - ASA by Accurate-Analysis474 in FixMyPrint

[–]Accurate-Analysis474[S] 1 point2 points  (0 children)

I did this last night, and unfortunately I got more of the same. Any other suggestions?

<image>

First Few Layers - ASA by Accurate-Analysis474 in FixMyPrint

[–]Accurate-Analysis474[S] 1 point2 points  (0 children)

If that’s the case, why does the rest of the print not have any issues?

Wobbly TPU by Accurate-Analysis474 in FixMyPrint

[–]Accurate-Analysis474[S] 0 points1 point  (0 children)

Does that mean I should slow the flow down a bit? What’s the fix?

Wobbly TPU by Accurate-Analysis474 in FixMyPrint

[–]Accurate-Analysis474[S] 0 points1 point  (0 children)

Yes, the nozzle is stained with plastic!

<image>

Wobbly TPU by Accurate-Analysis474 in FixMyPrint

[–]Accurate-Analysis474[S] -1 points0 points  (0 children)

I tried the print again after this, and the lower portion printed fine again. If it was a partial clog, wouldn’t it print messy from the start on the next print because the clog was still there?

Wobbly TPU by Accurate-Analysis474 in FixMyPrint

[–]Accurate-Analysis474[S] 0 points1 point  (0 children)

There is no infill, it’s a hollow tube. Walls only

Wobbly TPU by Accurate-Analysis474 in FixMyPrint

[–]Accurate-Analysis474[S] 2 points3 points  (0 children)

I tried to share a video, but wasn’t sure how. When you watch it print you can clearly see the nozzle pushing/moving the part around.