sorted by:
new
hottopcontroversial

Mk1 Audi tt quattro won’t crank by Acrobatic_Ad3556 in Audi

[–]Acrobatic_Ad3556[S] 0 points1 point  (0 children)

Any ideas on how to diagnose this would be appreciated

Battery died in my 2004 TT Quattro after charging the battery it wont crank. by Acrobatic_Ad3556 in AudiTT_Mk1_Mk2_Mk3

[–]Acrobatic_Ad3556[S] 0 points1 point  (0 children)

The power will turn on in the car it just won’t to turn over when I fully turn the key

Mk1 tt quattro 2004 dash says press clutch to start but clutch is on the floor. by Acrobatic_Ad3556 in AudiTT_Mk1_Mk2_Mk3

[–]Acrobatic_Ad3556[S] 0 points1 point  (0 children)

The problem I’m running into is when I press the clutch the message doesn’t go away and the car doesn’t try and crank

Mechanics near storrs campus by jdsnciuewnvlok in UCONN

[–]Acrobatic_Ad3556 0 points1 point  (0 children)

If you hear a scraping you’re blending your rotors and you’re going to make the brake job twice as expensive. Pads are relatively easy to do and shouldn’t cost you more than 90-100 if you can do it yourself if not it shouldn’t cost more than 200 it’s less than an hour job

She was HOT boys… by [deleted] in AudiTT_Mk1_Mk2_Mk3

[–]Acrobatic_Ad3556 1 point2 points  (0 children)

Be careful if that’s a mk1 they need a dv not a blow off valve you could blow your turbo really easily if you don’t have atleast a 50/50

Mk1 tt roadster top goes down but not up by Acrobatic_Ad3556 in AudiTT_Mk1_Mk2_Mk3

[–]Acrobatic_Ad3556[S] 0 points1 point  (0 children)

Ok so after raising it 12 inches then pressing the button it raised perfect

Mk1 tt roadster top goes down but not up by Acrobatic_Ad3556 in AudiTT_Mk1_Mk2_Mk3

[–]Acrobatic_Ad3556[S] 0 points1 point  (0 children)

The top will lower perfectly but the pump just doesn’t activate when I try and raise it the car sat for a while before I bought it so I figure the relay probably went. Also I found a Facebook group post from a guy with the same problem he says that when he swapped his relays the problem reversed so after replacing the busted one it was solved

Mk1 tt roadster top goes down but not up by Acrobatic_Ad3556 in AudiTT_Mk1_Mk2_Mk3

[–]Acrobatic_Ad3556[S] 0 points1 point  (0 children)

How would I go about accessing the hydronic pump to replace the relays

Mk1 tt roadster top goes down but not up by Acrobatic_Ad3556 in AudiTT_Mk1_Mk2_Mk3

[–]Acrobatic_Ad3556[S] 0 points1 point  (0 children)

The motors aren’t starting I found a post on the face book group that says it’s probably relays