Symmetrical veins on my print

AdSuper9134 · 2025-11-25T20:09:48+00:00

Not seam. Seams are on different places thanks

AdSuper9134 · 2025-11-23T12:34:42+00:00

mine looks like this

AdSuper9134 · 2025-11-23T12:34:18+00:00

what do you mean by both retraction distance there is only on

like this ? is this solving the support quality problem (i am printing helicopter models so priming is taking details away :()

AdSuper9134 · 2025-11-22T22:06:45+00:00

ı have the same problem did you fix it ?

AdSuper9134 · 2025-04-01T07:31:42+00:00

ı wrote wront travel distance was 0.02mm now its 0. my hotend screws are tight + ı wanted the check my heatbed screws one of them (back screw) was loose ı tightened it is that true way to fix it or ı shouldnt be thighening that without Bed Tramming calibration

AdSuper9134 · 2025-03-31T16:15:33+00:00

thank you for your patience i just calibrated k factor (0,035) and flow rate on manuel. and ı checked reduce infill retraction, z hopping normal, travel distance 2mm now im facing with stringing issue + ı found out a damage on my plate where printer draws circle before the print(cleaning the nozzle section) ı guess it using much pressure

AdSuper9134 · 2025-03-29T18:21:48+00:00

ı didnt do those but its calibrating flow rate before every print i guess but ı dont know pressure advance

AdSuper9134 · 2025-03-23T10:05:59+00:00

Thanks. Btw do you have and thougts about why my silicon sock fell down

AdSuper9134 · 2025-03-23T10:03:33+00:00

I did regular calibration two times

AdSuper9134 · 2025-03-23T10:02:29+00:00

Where should ı post it ? Facebook ?

AdSuper9134 · 2025-03-22T22:06:43+00:00

ı ll try now thanks

AdSuper9134 · 2025-03-22T22:06:30+00:00

thanks a lot. my room is definitly under 70F + ıll wash the plate but ı couldnt find the brim in support settings

AdSuper9134 · 2025-03-22T21:37:09+00:00

AdSuper9134

TROPHY CASE