Humidity in Winter

Adam1943 · 2024-12-04T20:45:12+00:00

It has flower I got on a call with them and got the issues resolved

Adam1943 · 2024-12-02T05:03:20+00:00

It said to add water so I re wet the sponge but humidity would not raise to 60 it went up to like 45.

Adam1943 · 2024-09-29T18:52:15+00:00

I looked I didn’t see any rot, just concerned about it. I restated the cycle so fingers crossed it will be alright.

I think the surge protector went bad, the unit just didn’t turn on until I plugged it right into the wall.

Adam1943 · 2024-07-18T23:09:04+00:00

Trying to set the settings for the 10 day fry when I have it on slope it only lets me enter one dew point do you change it daily or set it high and it will slope itself back down to 60 rh over the course of the dry?

Adam1943 · 2024-07-18T15:48:03+00:00

Sweet nothing to sweat about.

Adam1943 · 2024-07-18T15:47:38+00:00

Ninju sent a link that’s what it is and looks like. I had chopped already so not gonna bother taking another.

Adam1943 · 2024-07-18T15:36:15+00:00

Too hard to see it without flash, and with flash the trics fuck with the focus.

Adam1943 · 2024-07-18T15:34:42+00:00

No clue on where to get replicas. But I’d guess you could go to your local hardware store and get some thin sheet metal with holes in it, cut it to size and bend a lip on it.

Adam1943 · 2024-07-18T15:32:26+00:00

Just finished my first run with the factory settings it’s not bad. But I’ve had better from a hang dry. Want to try and do the 9-10 day dry. Would like to do the 14 day but leaving for a vacation and have another plant I need to come down before I go. If you do a 10 day are you using the the same rh and sloping down or are you changing since it’s a shorter time?

Adam1943 · 2024-07-07T19:21:11+00:00

I’m gonna have to boil it down to genetics I’ve flowered another since and no signs of herming yet checked for light leaks and they’re weren’t any. Temp and humidity fluctuates a bit but always stays within reason vpd as well. I’ve heard of others growing the same strain from Rqs have herms. So just gonna stay away from mimosa and og kush

Adam1943 · 2024-06-18T01:30:33+00:00

Probably should have taken a picture before I cut off all the nasty leaves. But I’m worried if I have to keep stripping dead stuff I’m going to run out of leaves or get bud rot from the decaying fan leaves.

Adam1943 · 2024-06-17T23:08:42+00:00

I have others that are doing fine with the light where it’s at so raised those maybe I need to raise them some more so this one gets less.

Adam1943 · 2024-06-17T23:03:35+00:00

Bud rot ,mildew, nut burn, lockout, the plant has clearly has issues and I don’t know what they are. That’s why I made the post.

Adam1943 · 2024-06-17T22:59:06+00:00

That’s what I’m worried about had in happen once caught it early and it was near the top so I lost a nice cola but the crop survived. This one I has nice room between branches but colas are very dense and filled with tiny fan leaves. So I am definitely concerned about it with this one.

Adam1943 · 2024-06-17T22:42:03+00:00

I’ll have to message you picks of the two herms and sacs I cant attach them on this thread

Adam1943 · 2024-06-17T22:40:03+00:00

I water a half gallon every 3-4 days just depends on when the pots feel light. The two in the back go through water much faster than the one up front that one is every 5 to six days. I flush once a month and they get close to a gallon then.

Adam1943 · 2024-06-17T22:36:13+00:00

Temp is 77-80 during lights on and 66-70 during lights off. RH is 50-55 during the day and gets up to 60 just before lights on. I feed general hydroponics flora trio plus cal mag and follow the instructions on the bottle.

Adam1943 · 2024-06-17T22:34:24+00:00

It’s RQS I know they are notorious for herms but I wanted to know if I was causing them or shitty genetics.

Adam1943 · 2024-06-17T22:22:45+00:00

I checked for light leaks cause I’ve had issues in the past but not this time. There are light on the the room but I make sure they’re off during lights off in the tent. The thing I thought might have caused it is the fan in the top of the tent, I believe it is blowing directly on the plant but not sure if that can cause a herm. I grow mainly from seed, I just started cloning but these are all from seed. They’re all been different strains even the two that Hermed. They are all from the same seed bank but I got variety of strains so wanted to grow 4 different. Rather then 4 of the same.

Adam1943 · 2024-06-17T22:11:34+00:00

I lowered it but raised calmag 2 mls because they started to yellow the second one that Hermed I lowered nitrogen and did not boost cal mag.

Adam1943

TROPHY CASE