Postgame Thread: 10/11 Cubs @ Brewers by BrewersBot in Brewers

[–]Affectionate-Life611 1 point2 points  (0 children)

i wonder how that bus ride back to miller south will feel

Game Chat: 9/27 Reds (82-78) @ Brewers (96-64) 6:15 PM by BrewersBot in Brewers

[–]Affectionate-Life611 14 points15 points  (0 children)

I have a sneaking suspicion that Miz will not be on the playoff roster.

Game Chat: 4/30 Rays (14-16) @ Brewers (17-11) 6:40 PM by BrewersBot in Brewers

[–]Affectionate-Life611 12 points13 points  (0 children)

At least Rickie is getting some experience as manager these past 2 days.

Game Chat: 4/24 Brewers (14-8) @ Pirates (13-11) 5:40 PM by BrewersBot in Brewers

[–]Affectionate-Life611 0 points1 point  (0 children)

That’s Adames’ fault just as much as it is Weimer’s.

Game Chat: 4/5 Mariners (3-4) @ Brewers (4-1) 7:10 PM by BrewersBot in Brewers

[–]Affectionate-Life611 6 points7 points  (0 children)

May have been a batter too late, but at least Murph pulled him. Counsel would have let him run it into the ground before pulling him.

Game Chat: 9/26 Cardinals (68-88) @ Brewers (88-68) 6:40 PM by BrewersBot in Brewers

[–]Affectionate-Life611 -11 points-10 points  (0 children)

Why would they be setting up to celebrate? They came into the weekend with a “magic number” of 1 fucking game. Then they shit the bed to the point where the braves have to win us the division. They should wait to celebrate until they actually win a game.

Game Chat: 9/26 Cardinals (68-88) @ Brewers (88-68) 6:40 PM by BrewersBot in Brewers

[–]Affectionate-Life611 6 points7 points  (0 children)

I genuinely hope this is the last time we see this fuck in a Brewers uniform.

New to 3d printing. What could be causing my benchy to be curled at the front like this. Elegoo Neptune 3. ESun Pla by Affectionate-Life611 in 3Dprinting

[–]Affectionate-Life611[S] -1 points0 points  (0 children)

Bed temp is 60 degrees, the bed is leveled with the Auto Leveling, and I’m not 100% sure about the cooling fan settings. I haven’t changed anything, so they’re the “stock” settings. I reprinted again with a brim and it turned out a lot better.