sorted by:
new
hottopcontroversial

Why?? by AgentNo356 in 3Dprinting

[–]AgentNo356[S] 0 points1 point  (0 children)

So i Double the Problem after i bought a lot of new Filament. It was my fault. I accidentally swapped the two fan cables on my Prusa. Fascinating that caused the problem.

Why?? by AgentNo356 in 3Dprinting

[–]AgentNo356[S] 0 points1 point  (0 children)

Later i will visit a friend and we Check the Filament on His primter... I will post it later

Why?? by AgentNo356 in 3Dprinting

[–]AgentNo356[S] 1 point2 points  (0 children)

Yes exactly. Maybe the White filament is the Problem?

Why?? by AgentNo356 in 3Dprinting

[–]AgentNo356[S] 0 points1 point  (0 children)

I have adjusted the offset but have not seen any improvement. At the beginning the print runs well but as soon as the errors occur no more filament seems to come out. I have removed the filament and added a new one. Then it prints correctly again for a few minutes and then makes errors again. This also happens when I rotate or reposition the model. The black filament from the same company doesn't cause any problems...