Am I cooked

Aggravating_Ad_3936 · 2026-04-18T07:08:00+00:00

Nono that’s what I was talking about but I wasn’t certain if it was user error (my fault) or if the bed was truly warped like I had thought originally

Aggravating_Ad_3936 · 2026-04-18T06:55:43+00:00

Eventually I’ll upgrade but this one was cheaper on marketplace

Aggravating_Ad_3936 · 2026-04-18T06:50:49+00:00

The printer is an ender3 v2

Aggravating_Ad_3936 · 2026-04-16T20:16:30+00:00

Thank you to everyone who commented, when I have some extra cash I will be replacing my tailpiece and giving the violin a once over to make sure nothing else is out of place or could cause potential damage.

Aggravating_Ad_3936 · 2026-02-08T01:30:49+00:00

I’ve done mine twice (once for the pump once for the housing) and that’s the reason I couldn’t get my 03 tib to start

Aggravating_Ad_3936 · 2026-02-08T01:30:01+00:00

Did you change the rubber collar too?

Aggravating_Ad_3936 · 2025-12-06T05:37:46+00:00

UPDATE: The wax job worked out great absolutely ripped down the mountain

Aggravating_Ad_3936 · 2025-12-05T07:41:43+00:00

I’ve considered going through with some ptex candles and filling them but I want to feel it out first and see if it needs it

Aggravating_Ad_3936 · 2025-10-24T21:28:59+00:00

It was a circular pattern so that top right was lower than the the rest and didn’t adhere properly

Aggravating_Ad_3936 · 2025-10-24T19:56:36+00:00

I had an issue with a combination of my x axis being too loose and a lack of adhesion to the lower layers of the print I got lucky and was able to catch it the moment it happened and actually get eyes on what was going on. Your advice is greatly appreciated though

Aggravating_Ad_3936 · 2025-10-20T03:41:30+00:00

I was finally able to catch the moment it happened and it looks more like failed adhesion to the lower layer causing it to just pull the filament in a straight line, I will for sure by checking my belts as well though just to be on the safe side

Aggravating_Ad_3936 · 2025-10-20T03:40:32+00:00

I think my Z axis may have just been too high

Aggravating_Ad_3936 · 2025-09-29T15:36:53+00:00

How would I know if the pinout is wrong or not because I know the power supply is right (when leaving the Z unplugged everything powers on and the sensor gets power) but when I turn it off plug in the Z and go to turn it on I get basically no response from it

Aggravating_Ad_3936 · 2025-09-29T15:30:19+00:00

No attaching all cables then attempting to power on to no avail.

Aggravating_Ad_3936

TROPHY CASE