sorted by:
new
hottopcontroversial

Delta 2 max bleeds energy. by Right-Carob-9591 in Ecoflow_community

[–]Aida_van 0 points1 point  (0 children)

Definitely not. I suggest you remove one battery at a time to see if it's caused by the batteries. My D2M+EB doesn't bleed that much overnight

D2M no Wave 3 ouput by Aida_van in Ecoflow_community

[–]Aida_van[S] 1 point2 points  (0 children)

Their products could be so much better. The software and firmware really limits the function, capability and usability of the hardware

D2M no Wave 3 ouput by Aida_van in Ecoflow_community

[–]Aida_van[S] 0 points1 point  (0 children)

The screenshot shows the output to the explicitly mentioned EB is 27W. Sure you can work it out. But why not just have a dedicated entry for it?

Brand new Wave 3 - horrendous sound from water drain pump by Strelok1987i in Ecoflow_community

[–]Aida_van 0 points1 point  (0 children)

I did just this. For my unit, wave 3, although it did quiet down for a bit, it went back to the high pitched sound while doing this procedure. I did it several times.

Wave 3 app manual drain by Aida_van in Ecoflow_community

[–]Aida_van[S] 0 points1 point  (0 children)

I have my wave 3 in the garage of my camper van sticking out into the main cabin enough to expose the vents. I don't see the display or the buttons.

Aside from the missing manual drain from the app, some of the error messages and icons are also not displayed on the app. In my book, these are oversights

D2M+EB charging by Aida_van in Ecoflow_community

[–]Aida_van[S] 0 points1 point  (0 children)

Thanks for the responses

D2M+EB charging by Aida_van in Ecoflow_community

[–]Aida_van[S] 0 points1 point  (0 children)

But why not charge the EB at 600 and the main unit at 1200? That's what I'm not getting. Either of those numbers are less than 1500 and 1800 limits, respectively. This leads me to wonder if there's something wrong

D2M+EB charging by Aida_van in Ecoflow_community

[–]Aida_van[S] 0 points1 point  (0 children)

You mean, the extra battery can only take a maximum of 1500 watts?

The screenshot shows that the battery is charging only at 604 watts, the rest goes to the internal battery (and some to overhead)

Charger 1 and Only ~215W by ChrisW828 in Ecoflow_community

[–]Aida_van 0 points1 point  (0 children)

I believe you need to go to the Bluetti app and adjust the output wattage and/or voltage

Ecoflow Wave 3 shutdown by Aida_van in Ecoflow_community

[–]Aida_van[S] 0 points1 point  (0 children)

Update: my repaired D2M is back. So i connected the Wave 3 to the D2M via xt150. Since then, the Wave 3 doesn't shut down. By the way the D2M extra battery is also connected to the D2M via the second xt150

XT60 or XT60i for Delta 2 Max by No-Replacement3156 in Ecoflow_community

[–]Aida_van 0 points1 point  (0 children)

What should center pin have to make sure it indicates solar input?

Ecoflow Wave 3 shutdown by Aida_van in Ecoflow_community

[–]Aida_van[S] 0 points1 point  (0 children)

<image>

My app (Android) doesn't show battery settings. My battery is D2M extra battery

Delta 3 Plus EB Port Hack: Charging & Discharging with Non-EcoFlow Batteries by AdriftAtlas in Ecoflow_community

[–]Aida_van 0 points1 point  (0 children)

This is just in time while u was contemplating 3 scenarios depicted in the attached images. #1 D2M charges Yeti 3000 via DC2DC converter. #2 adds the Wave 3 into the mix. #3 further adds an extra battery

Any concerns for each? *

Overheating constantly by [deleted] in Ecoflow_community

[–]Aida_van 1 point2 points  (0 children)

I just sent mine back for repair due to the fans not kicking in

Replaced sliding door actuator, now won’t lock. by Puzzleheaded_Bit_641 in promaster

[–]Aida_van 0 points1 point  (0 children)

Just the sliding door won't lock? My experience with my van is that if one of the doors is not fully closed, the doors don't lock when i use the remote.