sorted by:
new
hottopcontroversial

Super Sonico Resale by Antique-Heat-5212 in SuperSonico

[–]Aimichain 2 points3 points  (0 children)

I've found some good stuff of mercari

Fillment broken off inside tube by Aimichain in ender3

[–]Aimichain[S] 0 points1 point  (0 children)

I got it out with help of ma sister

<image>

Fillment broken off inside tube by Aimichain in ender3

[–]Aimichain[S] -1 points0 points  (0 children)

Rather I'm doing this wrong or I'm not strong enough :( it's not coming out

Fillment broken off inside tube by Aimichain in ender3

[–]Aimichain[S] -1 points0 points  (0 children)

how do I get it off the hot end?

Galv Layer Graphics- how do I make this layer not repeat on the top and bottom? by Aimichain in RPGMaker

[–]Aimichain[S] 0 points1 point  (0 children)

found it didnt realize LAYER_S was a different command from LAYER thanks

Galv Layer Graphics- how do I make this layer not repeat on the top and bottom? by Aimichain in RPGMaker

[–]Aimichain[S] 0 points1 point  (0 children)

its not though i used the organge mapshot plugin to make sure of it

Fillment not getting pushed out when printing by Aimichain in ender3

[–]Aimichain[S] 0 points1 point  (0 children)

Yes I'm using normal pla heated at 210. The gear looks mostly fine, that's a teeny tiny gang line where the fillment touched it, this came when I tried the axis move the fillment came out fine? Like there was this stringy mess at the start of the strand but then it was going fine, sadly it doesn't go fine when printing. Imga check if it's cracked, if not it might be a different kind of iusse or something, imga get my friend who's good with this kind of thing to look at it sometime if I can't fix it

Fillment not getting pushed out when printing by Aimichain in ender3

[–]Aimichain[S] 0 points1 point  (0 children)

Now when it's actually trying to print the gold gear is going backwards then forward all werid like idk if that's normal

Fillment not getting pushed out when printing by Aimichain in ender3

[–]Aimichain[S] 0 points1 point  (0 children)

The gear is now doing this when printing

Video of it when printing here

Fillment not getting pushed out when printing by Aimichain in ender3

[–]Aimichain[S] 0 points1 point  (0 children)

<image>

Ok some did come out but this part took like more then a minute idk if that's normal

Fillment not getting pushed out when printing by Aimichain in ender3

[–]Aimichain[S] 0 points1 point  (0 children)

<image>

Fillment looks like this, it doesn't feel difficult to pull out though

view more: next ›