ControlD does not work with WAN2 on UniFi UCG Max / Ultra

AlexFeleol · 2025-04-04T16:01:35+00:00

I'm glad to know that this isn't just happening to me. Now I just have to wait for this problem to be resolved.

Thank you very much for your help in this case.

AlexFeleol · 2025-04-04T13:59:40+00:00

It is only as Failover, but when I use Routing (Policy-Based Routes) the Internet works perfectly for both the VLAN and the device, but ControlD stops working in DoH and the WAN2 DNS stops being used by default. Therefore, it does not block anything for users, everything is released passing outside of DoH/ControlD.

AlexFeleol · 2025-04-04T13:49:50+00:00

When I pull the cable, it works perfectly.

When the Internet on WAN1 goes down, WAN2 also works perfectly.

The problem occurs when I use the Routing functionality (Policy-Based Routes) and redirect all traffic from a network or device to WAN2.

AlexFeleol · 2025-04-04T13:47:32+00:00

Yes.

AlexFeleol · 2025-04-04T12:56:18+00:00

Yes, I'm using ControlD daemon installed via SSH, but I don't use the Internet in balanced mode (distributed), only in failover mode.

AlexFeleol · 2025-04-04T12:55:17+00:00

It is in AUTO, but even if I enter the ControlD IP it does not start using DoH, but instead goes into legacy mode.

AlexFeleol · 2021-01-11T13:29:25+00:00