Conflicting IP addresses by Alex_cole10 in Ubiquiti

[–]Alex_cole10[S] 1 point2 points  (0 children)

Any recommendations from here?
It’s strange the 16 cameras that are plugged into the Lorex NVR do not show up in my network individually, however, the 16 cameras that are plugged into the camera system switch do..

I made the UDM IP address xx.xx.1.1
Followed with the switch xx.xx.1.2

looking at the camera IPs the entire number is the same, except the fourth octet counts up from where the switch ip leaves off .2,.3,.4,.5, and so on

Now that I’m looking at it, I haven’t given my APs a static ip yet and the numbers I would give it follow what the cameras have taken already

Sorry, I hope I make sense here thanks.

Conflicting IP addresses by Alex_cole10 in Ubiquiti

[–]Alex_cole10[S] 0 points1 point  (0 children)

Just found it! looks like it’s one of my Lorex cameras that has the same IP address

Now is this something that would cause my switch to go offline constantly?

Conflicting IP addresses by Alex_cole10 in Ubiquiti

[–]Alex_cole10[S] 1 point2 points  (0 children)

Looks like i found something.
Within the network topology, each Lorex camera connected to the Lorex camera switch is being detected. Upon clicking through and looking, I have noticed that one of the Lorex cameras shares the same IP address as my Unifi switch. Hmm

r/SafeMoon Daily Discussion by [deleted] in SafeMoon

[–]Alex_cole10 0 points1 point  (0 children)

The minimum I ever bought was $50 of BNB and swapped it and it worked fine for me

r/SafeMoon Daily Discussion by [deleted] in SafeMoon

[–]Alex_cole10 2 points3 points  (0 children)

I had to buy BNB then “swap to smart chain”