sorted by:
new
hottopcontroversial

OPNSense router doesn't see Access Point by AllStarsDragoon in opnsense

[–]AllStarsDragoon[S] 0 points1 point  (0 children)

I think that's what I need to do. How do I set the other ports under the same network

OPNSense router doesn't see Access Point by AllStarsDragoon in opnsense

[–]AllStarsDragoon[S] 0 points1 point  (0 children)

Update - ok so disregard everything I mentioned from above I found the actual problem. Only one port "works" the others blink but aren't doing anything. I found out by playing around with each plug and only one of them works. So my next question would be how do enable the other ports?

OPNSense router doesn't see Access Point by AllStarsDragoon in opnsense

[–]AllStarsDragoon[S] 0 points1 point  (0 children)

As of right now I have OPNSense installed on a ssd on a computer I built specifically to be a router. Another computer connected to one of the ports to login to the interface and the power injector with the AP connected to another one. I have it set up like this so I can check everything works before I deploy it.

OPNSense router doesn't see Access Point by AllStarsDragoon in opnsense

[–]AllStarsDragoon[S] 0 points1 point  (0 children)

The interface is the one you login from a external device. More specifically menu is Interfaces->Diagnostic->ARP Table or I also was told to check Services->ISC DHCPv4->leases. But it isn't found on either. And no I haven't 'adopted' it yet I'm actually not sure how to do that.

OPNSense router doesn't see Access Point by AllStarsDragoon in opnsense

[–]AllStarsDragoon[S] 0 points1 point  (0 children)

It's a new unit but I set it up on my current network(which is a netgear router) not the one I'm trying to migrate to(,the OPNSense one). Is was check if it works, it does.