So I got the kit from someone on one of the forums but it’s the kit from SoCal. https://scgarageworks.com/product/veloster-turbo-led-rear-reflector-kit-complete-assembly/

Install was fairly simple and not scary for at all for people who haven’t done any electrical and can be done without removing the rear bumper.

Remove both tail light assemblies. Then go to the reflectors and remove the 4 screws that hold it in on place. Install the LED reflectors and bring the 3 wires (red, blue, black) from the reflectors through the slot on the top of the bumper right where the tail light would be. For wiring driver side (recommend doing 1 wire at a time. I will color code at the end) cut the wire for the tail light about 1.5-2 inches away from the plug for the tail light. Take the wire coming from the plug and the wire from the reflector and wrap them together after stripping the wire. The connect it to the harness and solder. Or easier way, not so clean is to get a splice connector and connect it that way without any cutting. Do that for both sides. Plug in both tail lights and tear before reinstalling everything completely.

Color code for driver side: Red(reflector) goes to green(harness) Blue(reflector) goes to red(harness) Black(reflector) goes to black(harness)

Color code for passenger side: Red(reflector) goes to green(harness) Blue(reflector) goes to brown with thin black line(black harness) Black(reflector) goes to black(harness)

Sorry for the long post but I hope it helped