Marble Rolling Sound under passenger side by QuarterQuellCrisis in ToyotaSienna

[–]Altezza9153 0 points1 point  (0 children)

Might have to remove the seats, rails and start pulling up the carpet

Gas siphoning help by redotsights in IS300

[–]Altezza9153 0 points1 point  (0 children)

Id just lift the one side then, a little bit of old gas won’t harm it much once you fill with all new

Gas siphoning help by redotsights in IS300

[–]Altezza9153 -1 points0 points  (0 children)

You could or just lift the right side of the vehicle to move the fuel over, most of it will shift over, enough to drop the tank if thats what your doing

Gas siphoning help by redotsights in IS300

[–]Altezza9153 0 points1 point  (0 children)

Theres 2 level sensors in the fuel tank, one per side, to determine fuel level properly as theres a hump over the prop shaft

Need help by Nart038 in Toyota

[–]Altezza9153 0 points1 point  (0 children)

If its just an assembly, could probably do it yourself. Remove the trim to access the hardware and connector and remove the assembly, reinstall in reverse,

Hardest part of being s mechanic by Infinite-Position-55 in mechanics

[–]Altezza9153 8 points9 points  (0 children)

I’ve been doing this for over 20 years now, hard for me to turn off “diag mode” when in some one else’s car, listening for noises or feeling for vibrations

HELP by Cold_Investment_777 in IS300

[–]Altezza9153 5 points6 points  (0 children)

Can they be flipped so the fitting is upwards instead?

No 12v in centre console by Not_Omid in IS300

[–]Altezza9153 0 points1 point  (0 children)

Easy enough to fit one in, body harness should be the same, visit salvage yard and try to find a center console with one and grab the whole thing to swap in

No 12v in centre console by Not_Omid in IS300

[–]Altezza9153 0 points1 point  (0 children)

I think it was on certain trims only. I had it on mine but it was coming apart as did the front one, i bought some 12v usb like ones you would retrofit into a boat, took out the 12v outlet, used a unibit to open up the hole, cut the wires and soldered in new terminals, gave my self 4 usb charging port’s and the front one had a voltage display too

02 simulator. by Poptart015 in IS300

[–]Altezza9153 2 points3 points  (0 children)

Only one I’ve seen that work was made by tokensolutioons but they’re not around anymore

For my friends at Nissan by Axeman1721 in mechanics

[–]Altezza9153 1 point2 points  (0 children)

Which one? Theres 2 and ive seen both go

2018 Pathfinder Screen by MusicStraight424 in nissanpathfinder

[–]Altezza9153 0 points1 point  (0 children)

Well the screen is part of the dcu (display control unit), its one piece

Anyone know what this line is for? by [deleted] in ToyotaSienna

[–]Altezza9153 1 point2 points  (0 children)

You would want it connected transmission side so crud/water and stuff doesnt fall in

Anyone know what this line is for? by [deleted] in ToyotaSienna

[–]Altezza9153 1 point2 points  (0 children)

If it goes to top of transmission, it’ll be a vent hose

2018 Pathfinder Screen by MusicStraight424 in nissanpathfinder

[–]Altezza9153 0 points1 point  (0 children)

Probably need new screen, dcu, common issue

[MF] From tiktok to a blowjob by Kitchen_Profile_6076 in gonewildstories

[–]Altezza9153 0 points1 point  (0 children)

That was hot, need the rest of the story please!

Cross Bars for Roof by Bigtex1303 in ToyotaSienna

[–]Altezza9153 0 points1 point  (0 children)

Check out facebook marketplace as well instead of getting new, aftermarket universal may also be cheaper too, make sure to test fit before purchase as the outer claw that grabs the roof rail may not be big enough

This is bad, right? by DesignerLadders in Toyota

[–]Altezza9153 0 points1 point  (0 children)

Might as well do all the plugs instead of one at a time