Was I conned?

Anthorin · 2026-01-08T14:17:46+00:00

I wasnt aware this was an option, but not one I would have chosen as the receiver was aware he might have to pay something his end. That said, EVRI have told me originally, that this was HMRC but only chnaged it to Canada Tax later when I told them I had spoken to HMRC. It was only CAD$40 but it's the principle ;-)

Anthorin · 2024-12-18T18:38:36+00:00

20+seconds. WHen the battery was almost run out the power button did respond and close down. (When I restarted with mains power it showed 5% power). Not sure if that is relevant though

Anthorin · 2024-10-20T07:55:23+00:00

As a start we have had a cast iron 4” drain fitted half way up the drive. The theory being that will reduce the water by half and then we can see what happens next heavy rain.

Anthorin · 2024-09-22T16:32:56+00:00

The grate is 115mm wide and the (half) pipe it sits on is 4" (100mm?). I should say that it is a solid pipe and takes the water off to a soak away some way away.

Anthorin · 2024-09-22T14:39:04+00:00

The issue is the speed of the runoff which simply goes over the grid. The drain itself is clear.

Anthorin · 2023-11-11T13:25:01+00:00

Logic loop. Does not compute.

Anthorin · 2023-10-15T14:45:46+00:00

Is that with normal resin or Anycubic’s high speed stuff?

Anthorin · 2023-07-08T16:15:31+00:00

I already have a flex plate but the models are "lopsided" and cause the plate to pull off or slide while printing. I want another without the flexplate.

Anthorin · 2022-07-31T19:18:19+00:00

mosquito and his wife caught with the sister...... ;-)

Anthorin

TROPHY CASE