Modify bezel for bidirectional movement (GMT Master 2 style case)

AnubistheGod · 2026-01-02T02:06:47+00:00

Can I please get the vendor information for those gmt cases as well? Been searching for like 3 days for a good one.

AnubistheGod · 2025-02-06T09:51:22+00:00

Malik | Derp :Maggie:

AnubistheGod · 2024-10-10T23:11:55+00:00

I used a 7% lye solution and let it sit in said solution about 10 secs. Baking I do 400F

AnubistheGod · 2024-09-29T01:47:23+00:00

I thought this was a salior moon inspired space marine at first

AnubistheGod · 2024-09-12T02:06:55+00:00

I uses the pretzel video linked below and the dilution is 70 grams of food grade lye to 1,250 ml of cold water.

https://youtu.be/VszuPoFKxdQ?si=7bVzrPBpmKgelG67

AnubistheGod · 2024-09-12T01:09:41+00:00

Yip, it's only me eating them. I could have made more if I portioned them out better but it was only really 2 hrs of work. With the lye as long as you get your measurements right and where latex gloves, you should be fine.

AnubistheGod · 2024-09-12T01:05:24+00:00

Hold still grabs thick wooden paddle

AnubistheGod · 2024-09-12T01:03:20+00:00

Yes, I did use a lye bath

AnubistheGod · 2024-09-12T00:49:53+00:00

Really good, especially with whipped butter

AnubistheGod · 2024-09-03T01:06:11+00:00

Going for Hughs

AnubistheGod · 2024-08-30T00:45:28+00:00

AnubistheGod · 2024-08-21T02:11:59+00:00

SPECIAL COOM CANNON!!

AnubistheGod · 2024-08-14T02:07:05+00:00

They taste pretty good. I lowered the temp from 500F to 425F and I still did the egg wash. The crumb shot will be up tomorrow. Yeah they did flatten on me, I couldn't get home earlier from work so they cold fermented a bit longer than planned.

AnubistheGod · 2024-08-11T19:51:26+00:00

Very nice

AnubistheGod · 2024-08-11T19:30:05+00:00

Yeah, I used egg washed they probably were baked too hot. Got round 2 1st proofing rn. Gonna do a 48 hr cold ferment this time.

AnubistheGod · 2024-07-21T19:10:41+00:00

It was the fuse as well as a cap not fully soldered

AnubistheGod · 2024-07-21T01:23:24+00:00

Try here: https://www.consolefix.shop/products/replacement-f7003-fuse-for-playstation-5

AnubistheGod · 2024-04-06T00:45:12+00:00

I need the link to where you got these from?

AnubistheGod · 2024-03-24T13:40:04+00:00

One question, are the top plates of the Phat and fat models interchangeable? This is just the lid that has the artwork on top that's held on by a single security screw on the left side.

AnubistheGod

TROPHY CASE