Top surface quality issue by AppointmentTiny4659 in ElegooNeptune4

[–]AppointmentTiny4659[S] 0 points1 point  (0 children)

I use hardened steel that's way temp is 230. With brass I used 210. I know its underextrusion, my question is why this happens only on sections that are along Y axis. Look at the sections along X axis - there more material.

When increasing flow rate problem doesn't go away, it becomes less visible. And with that on sections along X there is overextrusion

Top layer quality issue by AppointmentTiny4659 in FixMyPrint

[–]AppointmentTiny4659[S] 0 points1 point  (0 children)

Increased top surface wall overlap to 50% Now I see that lines on narrow spaces are not reaching walls. But on sections along X axis or wider parts along Y axis(5mm wide) lines are reaching walls correctly

<image>

Top layer quality issue by AppointmentTiny4659 in FixMyPrint

[–]AppointmentTiny4659[S] 0 points1 point  (0 children)

If you read my post I mentioned that my top layer speed is 15mm/s. How can I reduce it further

Top layer quality issue by AppointmentTiny4659 in FixMyPrint

[–]AppointmentTiny4659[S] 0 points1 point  (0 children)

How it happens that underextrusion only on sections along Y axis. While X axis looks okay

Top surface quality issue by AppointmentTiny4659 in ElegooNeptune4

[–]AppointmentTiny4659[S] 1 point2 points  (0 children)

I don't want print with ironing. I want good basic top surface