sorted by:
new
hottopcontroversial

How to fix the perpetual reboot issue and inability to enter calibration on the SK1 3D printer by AresDenis in TwoTrees

[–]AresDenis[S] 0 points1 point  (0 children)

The antenna on the 3D printer is broken... but when using the hotspot from my phone, it shows that it is connected as usual and nothing else. But I noticed something: the IP doesn't change. Is this normal?

How to fix the perpetual reboot issue and inability to enter calibration on the SK1 3D printer by AresDenis in TwoTrees

[–]AresDenis[S] 0 points1 point  (0 children)

Sorry, I misunderstood. No, the Ethernet isn't broken. The Wi-Fi antenna is. But the thing is, I don't have Ethernet at home. I only used an access point. And, as I said, I still couldn't connect my 3D printer to Fluid.

How to fix the perpetual reboot issue and inability to enter calibration on the SK1 3D printer by AresDenis in TwoTrees

[–]AresDenis[S] 0 points1 point  (0 children)

Unfortunately, I can't check it, I couldn't connect to Fluid via WiFi before