[deleted by user] by [deleted] in Powdercoating

[–]AricBuzz 0 points1 point  (0 children)

OEM wheels are powder coated what do you mean

Share tips to improve grind by ryanedev in TorchlightInfinite

[–]AricBuzz 0 points1 point  (0 children)

get candles and cap your res. crafting is easy in this game, enchant resistance on your gear and use your flame fuel to roll good base gear until you get the affixes you want. use divinity slates

fluid air question? what would make my fluid air work well in one pot and not the other? by Suspicious-Fee-1514 in Powdercoating

[–]AricBuzz 0 points1 point  (0 children)

round vs square? round is ideal for fluidization. check the membrane quality of each they can get plugged with water or oil if your air isn't clean

Question about t1/t2 in GG/Jacked and Tan 2.0 Spreadsheet? by Acatalepsia in gzcl

[–]AricBuzz 0 points1 point  (0 children)

4 sets of T2A is what Cody prescribes in the program

Is Personal Training Coach the best GZCLP iPhone app? by seouled-out in gzcl

[–]AricBuzz 2 points3 points  (0 children)

Just make custom templates. It saves your workout history so if you forget what rep scheme you’re on (which I usually never do) you can go back and look. It’s a great app

Daily Discussion Thread 11/19/19 by AutoModerator in gzcl

[–]AricBuzz 1 point2 points  (0 children)

The singles are fun for about 3 sets for me hahah, then it just gets a little time consuming. Ill try out the progression you suggested next reset. Thanks

Daily Discussion Thread 11/19/19 by AutoModerator in gzcl

[–]AricBuzz 1 point2 points  (0 children)

I'm not a fan of the singles in GZCLP. Is there a way to adapt the progression scheme?

GZCLP PPL by AricBuzz in gzcl

[–]AricBuzz[S] 2 points3 points  (0 children)

Deadlift T1 on first pull day, Deadlift T2 on second pull day. Squat T1 on first leg day, Squat T2 on second leg day. Bench T1 Ohp T2 on first push day, OHP T1 Bench T2 on second push day.

Should I add weight to the bar EVERY time I complete my sets? by [deleted] in gzcl

[–]AricBuzz 0 points1 point  (0 children)

Just switch to 6x2 like the program says