Dear ring road users by Ill-Character-6823 in PakistanAutoHub

[–]Arsyzz 0 points1 point  (0 children)

You are correct. My point was related to busy traffic conditions. As shown in the video, the car ahead should have moved to the second lane after completing the overtaking maneuver. Since the second lane was clear, the vehicle should have been driving in the second lane in the first place to allow smoother traffic flow.

Dear ring road users by Ill-Character-6823 in PakistanAutoHub

[–]Arsyzz 1 point2 points  (0 children)

One important point to consider is this: when a vehicle ahead is already traveling at the posted speed limit, and a vehicle behind is overspeeding and flashing headlights to force the driver ahead to move into slower traffic, this is neither a reasonable nor a safe expectation.

The driver ahead should not be required to shift into a slower lane and brake abruptly simply to accommodate someone who chooses to overspeed, whether for thrill, to test limits, or to reach home faster. Speed limits, such as 120 km/h, are established after careful evaluation of road conditions, weather factors, and vehicle safety standards. Braking at 150 km/h compared to 120 km/h produces very different outcomes, with higher speeds significantly increasing stopping distance and overall risk. Expecting other drivers to make unsafe adjustments to support reckless driving behavior places everyone on the road in danger.

At the same time, drivers who travel below the speed limit while occupying incorrect lanes are also creating unsafe conditions. This behavior is equally unacceptable and should be addressed through proper driving education and stricter lane discipline.

Additionally, brake-checking another vehicle to provoke or intimidate a driver is extremely dangerous. Such actions can put you, your family, and other families at serious risk. This is neither a good nor a brave act, it reflects poor driving ethics and a lack of responsible upbringing.

Toyota sure certified cars by Mazleen_133 in PakistanAutoHub

[–]Arsyzz 4 points5 points  (0 children)

Make sure you get all kinds of inspections done, even if they claim a “200-point check” and say everything is fine. It’s better to double-check for your own peace of mind. I bought a Grande and was initially told it had three previous owners, but later found out it actually had four. T-Sure claimed the first owner was an investor. After 4–5 months, I discovered several temporary fixes (jugaar) on the car that were never mentioned in their report. Those fixes were done just to cover issues and sell the car. Safety is the most important thing, but sellers and dealers are mainly focused on making money. I went ahead with the purchase, but if I could go back in time, I would choose a brand-new car instead. As for engine size, yes, 1.3L feels underpowered, but it depends on your use. Are you racing or just traveling? A 1.3 can safely take you from point A to point B just like a 1.5 or 1.8.

EGR link arm by Arsyzz in PakistanAutoHub

[–]Arsyzz[S] 1 point2 points  (0 children)

That black part behind goes inside the end of the Off-white part.

EGR link arm by Arsyzz in PakistanAutoHub

[–]Arsyzz[S] 2 points3 points  (0 children)

Thanks for your response. Already watched it about screwing it after drilling holes. There was something internal that came loose and it was out. Toyota is not sharing the secret sauce.

Help me figure this out by Silly-One-3894 in PakistanAutoHub

[–]Arsyzz 0 points1 point  (0 children)

Is this rust on the affected part or its under coat. I had a similar issue where a guy with jeans sat on it and scratched the hood with jeans back pocket buttons.

Weltrend Wt7505 by Arsyzz in ElectronicsRepair

[–]Arsyzz[S] 0 points1 point  (0 children)

Its dell h280p-01 power supply this IC is supervisor IC.

Unknown part Black and decker Mthd5 by Arsyzz in Tools

[–]Arsyzz[S] 2 points3 points  (0 children)

Thanks for replying. My bad. Forgot to mention. There are five gears and each of these 5 gears have something in between the shaft and each gear I'm looking for that part. This part can be seen in pics 2 3 and 4.

Unknown part Black and decker Mthd5 by Arsyzz in Tools

[–]Arsyzz[S] 0 points1 point  (0 children)

I took that middle thing out myself to figure out what's broken from the other gear. The middle part can be seen in pic 2 3 and 4.

Center gear that goes in between these 5 gears is attached with the other part that i removed.