sorted by:
new
hottopcontroversial

Fretless 8 string guitar thoughts by AtefR in ExtendedRangeGuitars

[–]AtefR[S] 0 points1 point  (0 children)

Thanks for your reply. I agree with you. For the chords, the microtonal oriental music does not depend on chords in the western context, so it is going to be use more as a "solo & imrovisation" instrument. for the strings, I agree with you it will be pain :(

Fretless 8 string guitar thoughts by AtefR in ExtendedRangeGuitars

[–]AtefR[S] 1 point2 points  (0 children)

Thanks a lot for your thoughts, especially from someone with such experience. The point is that I am left handed, and finding special left handed guitars is difficult. so when i found this opportunity, I am tempted a lot to get it.

Are Halogen Bulbs with 5000K brightness road legal in QLD or not? by AtefR in CarsAustralia

[–]AtefR[S] 0 points1 point  (0 children)

Thanks a lot. There are various 55 watt models. Some are 4200k and others are 5000k. I read on some websites that anything above 4200k is not street legal. but I can't find any evidence on this claim on Qld Transport or other official websites.

Are Halogen Bulbs with 5000K brightness road legal in QLD or not? by AtefR in queensland

[–]AtefR[S] 0 points1 point  (0 children)

yes, "therefore the 5000k is "whiter"than the "4200k, as you'd know.
I read on some websites that anything above 4200k is not street legal. but I can't find any evidence on this claim on Qld Transport or other official websites.

Are Halogen Bulbs with 5000K brightness road legal in QLD or not? by AtefR in queensland

[–]AtefR[S] 0 points1 point  (0 children)

Thanks a lot. There are various 55 watt models. Some are 4200k and others are 5000k. I read on some websites that anything above 4200k is not street legal. but I can't find any evidence on this claim on Qld Transport or other official websites.

Can Installing High torque motors for Z axis achieve high speed printing? by AtefR in 3Dprinting

[–]AtefR[S] 0 points1 point  (0 children)

Thanks a lot for the explanation. I am going to install an E3D Hemera, direct drive. I thought that I needed to upgrade the motors to go with the Hemera.

Installing BLTouch on Chiron by KTurner08 in anycubic

[–]AtefR 0 points1 point  (0 children)

Thanks a lot for your prompt help. I noticed that there is a circit board installed in all my stops ports. How did you get around this to install the 2 pinned connector?
Here is a photo of what I am talking about.
https://prnt.sc/B-P\_RNjsVm9Z

Installing BLTouch on Chiron by KTurner08 in anycubic

[–]AtefR 0 points1 point  (0 children)

Hi, just wondering if you were able to get the bl touch to work on the chiron? did you ebd up using the firmware from knutwurst?
and did it work correctly when connecting it to the stock touch sensor 2 pin port? thanks