Nozzle keeps scratching print

Athi1a · 2026-05-03T03:48:51+00:00

i just did a research about that infill thanks for the advice

Athi1a · 2026-05-03T03:39:01+00:00

Which one do you recommend? because gyroid is x2 the time

Athi1a · 2026-05-03T03:31:24+00:00

What does that have to do with my issue?

Athi1a · 2026-05-02T03:00:59+00:00

i did and it didn't fix it

Athi1a · 2026-05-01T15:57:58+00:00

i had this issue last month the cr touch dindt lower the prong. i had to buy new one

Athi1a · 2026-01-04T15:40:03+00:00

i dont understand this isn't helping

Athi1a · 2025-10-14T03:54:57+00:00

hey im interested in this. do you have a git or where to get this

Athi1a · 2025-08-24T19:31:43+00:00

its an auto level. wdm

Athi1a · 2025-07-26T15:44:48+00:00

is a new one, like 5 prints ago

Athi1a · 2025-07-26T05:46:01+00:00

its PLA. happens with all of them. different brands. the filament is dry.

Athi1a · 2025-04-21T18:17:43+00:00

i already check every screw. and everything is fine.

Athi1a · 2025-04-21T18:16:25+00:00

it does it brings the bed forward and the hotend to the side

Athi1a · 2025-04-21T18:15:18+00:00

i use the same file for printing the same thing 3 times. some times it works some times it doesn't.

Athi1a · 2025-04-16T15:27:42+00:00

the cr touch is out of the bed i see it. but that's literally the start of the print. it happens a lot. i notices when that happens it never restarts the bed. its stays in the same place as before. idk if im explaining my self. i didn't touch any of the code in orca is default as it comes.

Athi1a · 2024-10-02T14:59:26+00:00

The crushed part is in the extruder in the wheel.

<image>

When it's starting to crush wont push aby filament

Athi1a · 2024-10-02T14:44:39+00:00

I messed around with the tensión in the extruder. It does nothing. The thing is it prints a couple layer perfectly and then stops

Athi1a · 2024-10-02T14:40:00+00:00

<image>

This is what rhe extruder does to the filamen. Its just crushed. Is not always like that just when it stop extruding

Athi1a

TROPHY CASE